Cherry GS102301 Speed Sensor

Cherry's new GS102301 geartooth speedsensor is tested to SAE J1455. This digital output Hall effect speed sensor isself-adjusting over a wide range of magnetic flux densities, eliminating theneed to optimize the sensor position within a small magnetic flux operatingrange. This feature also compensates for target run out. The single hall platedesign is immune to alignment issues, allowing unlimited mounting positions.

Thisaddition to Cherry's family of near-zero speed sensors operates in temperaturesranging from -40 to 140C and meets IEC60529 IP68 standards for water immersion.The sensor also containscircuitry that protects it from EMI and ESD and is reverse battery protected. Thedevice requires a minimum input of 3mA to function properly.

Only2.80 inches long, in a straight, threaded housing, this sensor will fit into astandard M20 x 1.5 o-ring port andwithstands a maximum installation torque of 15 ft lbs. The Viton o-ring comespre-installed. The durable Stanylplastic housing, with itsresistance to environmental extremes, makes it suitable for a wide range ofvehicle speed sensing requirements in transmission, engine and brakingapplications. The device has been tested for environmental exposure perSAE J1455 Section 4.4.1, which includes immersion in engine and transmissionoils.

Manufactured with an open collector output, the GS102301requires a customer supplied pull-up resistor. Operating voltage is 5 to 30V dcat the nominal operating range. The GS102301 mates with the Packard Metri-Pack150.2 sealed female connector assembly 3F.

Features

Applications

Fordetailed specifications click here.

Cherry GS102301 Speed Sensor