If you bought all the parts new, it would cost you about $30 to make. Depending on where you live, it might take a couple of years to get that back, but your comfort level will be greatly improved. The circuit can be made to be much more precise if needed. I'd replace the SCR power supply with a zener diode circuit or added an electronic regulator. This would only be needed if you used the thermal air pump to pull air through the box. If you used an isolated 24 volt power supply, the temp sensor could be brought outside the box, eliminating the need for the thermal air pump and any kind of regulated power supply.
Clever design, Andrew. Congrats. I'm curious about the cost of this compared to conventional technology. Is the cost higher? Are there some applications that would need this extra precision at any cost?
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.