Several studies indicate that the noise generated by performing orthopaedic surgery has the potential to cause hearing loss. Noise produced by several orthopaedic surgical instruments such as saws, drills, and hammers during surgery exceeds 100 dB, especially during knee replacement procedures. Surgical protection suit may help to protect surgeon from noise-induced hearing loss.
I like the idea of a display, Greg - that would allow the user to know immediately whether or not the battery should be considered for service without any additional steps. Sounds like a good PIC project to me ;)
Yes, the data chip idea would be nice. Ideally, the charging station would have some type of display which would show the user what percent of charging cycles are left in the battery (and warn if a battery should be replaced soon).
That's a great idea, Greg - from a reliability standpoint they could then discard the battery before it neared the end number of its specified charge cycles - in a critical application such as this that might be a good approach to ensure sufficient battery life. For example - maybe a battery that is spec'ed at 500 charge cycles you could pull it out of service at 400 charge cycles.
It would be really nice to have a data chip in the battery pack that keeps track of the number of cycles and the maximum temperature of the battery pack - that might help you be able to tell when a failure is imminent.
Good point about monitoring remaining run-time to avoid unexpected power-down during operation. Is there also a feature on the charging station which monitors the number of charges each individual battery pack receives? (monitoring charge cycle life).
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Independent science safety company Underwriters Laboratories is providing new guidance for manufacturers about how to follow the latest IEC standards for implementing safety features in programmable logic controllers.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.