"I've noticed at our local Walmart that as I push some of the carts, I get a static discharge through my hands. It's really uncomfortable. Have other's noticed this same problem?"
Often you will see some versions of shopping carts with a discharge strap or small chain hanging down rubbing the ground. This also seems to be a greater problem with the newer plastic carts than the older metal carts... There has been alot of info about this problem with a specific retailer which you can find by searching: Wal-martshopping cart static electricity shock.
I once worked for a contract ICT test house developing test programs and fixtures. Our test head (HP3065) and debug bench was in a "static controled" room with a disapative carpet. One day durring the winter, I walked accros that rug, reached down into the empty patch bay of the test head and drew a 1" arc to one of the test card connections; it hurt like heck and I jumped back. I immediatley grabed the diagnostics fixture, and found that we had a dead analog card. It took two day of down time for HP to find the problem and get us a replacement card. So much for the anti static carpet. We got a lot more serious about wrist staps after we learned that we could not rely on the carpet any more.
Yeah 3drob... We get that too sometimes. I've been told by one EE that he's never zapped a board... 'Yet' is what I replied.
We have below 1% humidity in the dryrooms and an over active air exchange in one of those creates a bit of a breeze too. We do a good job of maintaining boot straps, wrist straps, ESD Lab coats as SOP in those... and we still get the occasional fire, so far though those always seem to be non-static events. Friction; go figure.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.