One quick note about refresh rates. Commercial movies do run at 24 frames per second, but their duty cycle is very high, so the "flicker" is less noticable. However, the larger the screen (peripheral vision "sees" flicker better) and brighter the movie is, the more noticable it becomes. Flicker doesn't bother me much (although I do notice it), but I find IMAX movies frustrating because I really WANT to enjoy them, but the flicker is just too much.
LED Christmas suffer a double whammy because not only do they have a 60 Hz flash rate, but the duty cycle is awful; for two reasons. The first is, as noted in the post, the BEST duty cycle to expect is 50%. The second is: you don't come anywhere near 50% because the LED's don't turn on until the very peak of the cycle. You may be lucky if you get 10-20% duty cycle.
I likc the idea of a high frequency, current regulated, square wave inverter. Perhaps in time for the next holiday?
I have encountered strings of outdoor LED lights made by Phillips that are wired in such a way that the first two LEDs at each end form the bridge rectifier. I rewored these to elimiate this feature which had thess four LEDs still flickering and dimmer than the rest.
Marty48, I agree that this should be housed in a waterproof box. I also recommend strain relief on the wires. One good pull on the device as presented could put bare wires on your ladder or wet bushes. And as someone mentioned, it should have a warning label that it is for LEDs only.
I believe it's because the tail-lights are lit with 100% duty cycle for the higher brightness stop-light mode. In tail-light mode, they run on a low duty cycle pulse to reduce the brightness. It's at a low enough frequency that the strobe effect can be seen. But probably higher than 120Hz.
I recall reading that when the first Tesla hydro plants were built at Niagra Falls, they produced 25Hz. When the river bank eroded, the power plant on the US side fell into the river. The new plant was built for 60Hz.
Last I heard, the Canadian side was still running at 25Hz, but it's used only to supply power to electric arc furnaces for aluminum refining.
Good historical points. There was also 16-2/3 Hz power at one time. The low frequencies were generally used for streetcars. I dont know if this was because they wanted slow-speed induction motors for direct drive, or they just wanted to use thicker iron. Our current 60 Hz grid is largely a relic of poor quality transformer iron in the early days. There was serious discussion in the 1950s of raising the grid frequency to 400 Hz, since modern iron could handle that with no great loss, and it would of course make all the transformers and motors MUCH smaller and cheaper, but replacing the installed equipment would be prohibitively expensive. It's interesting that we're gradually returning to that with the proliferation of VFD motor drives and universal switching power suppllies. It may be that at some point in the future we really will either convert the grid to a higher frequency or to DC, with solid-state converters at the point of service to handle legacy equipment.
Festo's BionicKangaroo combines pneumatic and electrical drive technology, plus very precise controls and condition monitoring. Like a real kangaroo, the BionicKangaroo robot harvests the kinetic energy of each takeoff and immediately uses it to power the next jump.
Design News and Digi-Key presents: Creating & Testing Your First RTOS Application Using MQX, a crash course that will look at defining a project, selecting a target processor, blocking code, defining tasks, completing code, and debugging.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.