HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
Page 1/4  >  >>
Ann R. Thryft
User Rank
Blogger
Re: Research for alternate Energy
Ann R. Thryft   4/25/2013 12:46:29 PM
NO RATINGS
I can see several flaws in that basic design concept/system architecture--what do cars do for power when they're not on the road? If it means they have to switch power sources, isn't that unnecessarily complex and costly? And doesn't it put too much "power" of another sort in too few hands?



Ann R. Thryft
User Rank
Blogger
Re: Research for alternate Energy
Ann R. Thryft   4/25/2013 12:44:06 PM
NO RATINGS
Mydesign, the energy requirements for a stationary object--such as an energy source for a building that provides lights, heating and outlets for plugging in electric/electronic devices--will be very different from an object that must a) propel itself somewhere, and usually also b) provide energy for lights, heating and outlets for plugging in electric/electronic devices. It takes a huge amount of energy to self-propel, which we moderns have perhaps forgotten, since we're so used to the combustion engine and the "horseless carriage." But that aside, solar power is simply another potential source for electricity for an electric vehicle, but one without nearly enough energy density.

Mydesign
User Rank
Platinum
Re: Research for alternate Energy
Mydesign   4/24/2013 11:33:43 PM
NO RATINGS
1 saves
Ann, I think other than moving applications, everywhere solar power generators are using. Especially with industries, hospitals, offices etc. But I think its bit difficult & not that much reliable in fixing solar panels over a moving object, especially automobile.

Cabe Atwell
User Rank
Blogger
Re: Research for alternate Energy
Cabe Atwell   4/22/2013 6:09:37 PM
NO RATINGS
Witricity... magnetic-resonance power coupling is not the only option.

There are plenty of places when power is delivered to vehicles through roads. Mostly in a finite area for testing, but it is happening. Perhaps that is best way to go?

C

Ann R. Thryft
User Rank
Blogger
Re: Research for alternate Energy
Ann R. Thryft   4/19/2013 11:38:08 AM
NO RATINGS
Mydesign, thanks for the clarification on your end. I'm not surprised that the numbers were run for household solar, not other applications. Household solar is on everyone's radar, but other uses have a lot less visibility. Too bad, since it would be good to have more data about other applications easily available.

Mydesign
User Rank
Platinum
Re: Research for alternate Energy
Mydesign   4/16/2013 11:15:12 PM
NO RATINGS
1 saves
Ann, thanks for the clarification. When I further dig in to the article, it seems that the ROI and other statical details mentioned are for solar energy for house hold purposes. Am not sure about such statists for automobiles.

Ann R. Thryft
User Rank
Blogger
Re: Research for alternate Energy
Ann R. Thryft   4/12/2013 11:50:49 AM
NO RATINGS
Mydesign, are you still talking about the use of solar energy for vehicles? In your previous comment on this, you mentioned that a Wikipedia article cited power density, cost and vehicle design considerations as constraints. I was pointing out that if cost is a problem, it probably has at least as much to do with the low power density, which would be an ongoing problem as a cost-of-ownership factor, as it would with the initial one-time cost of the solar module. So even if there's a 4-5 year ROI on the module--on a house or on a car--in a car there will still be a cost-of-ownership problem with low power density.

Mydesign
User Rank
Platinum
Re: Research for alternate Energy
Mydesign   4/11/2013 11:59:11 PM
NO RATINGS
1 saves
"cost is also a constraint, as you point out, but that's primarily because of the low energy/power density."

Ann, am not sure about the cost part. But for house hold purposes, vendors or service proving companies are clamming that ROI is possible within 4 year and there won't be any maintenance for 5-6 years.

Ann R. Thryft
User Rank
Blogger
Re: Excellent coverage
Ann R. Thryft   4/11/2013 1:14:04 PM
NO RATINGS
Thanks for the Witricity info, Cabe--I didn't know about it either.

Ann R. Thryft
User Rank
Blogger
Re: The various alternative fuels, who will win?
Ann R. Thryft   4/10/2013 12:20:27 PM
NO RATINGS
LP (liquid propane) has been proposed several times as a transportation fuel. But even as a fuel for use in the home--as it is out here in the woods--it is hindered by the main problem of distribution. It has to be trucked in big tankers since it won't flow in pipes as natural gas does. OTOH, gas stations here routinely dispense LP, at least into small portable handheld tanks.

Page 1/4  >  >>


Partner Zone
Latest Analysis
An in-depth survey of 700 current and future users of 3D printing holds few surprises, but results emphasize some major trends already in progress. Two standouts are the big growth in end-use parts and metal additive manufacturing (AM) most respondents expect.
Technology and global expansion are playing key roles in making manufacturing an attractive field for women to join, more than ever before, said the president of a woman-owned family of companies.
A few years ago, reshoring roared onto the scene as the next great movement in manufacturing, but the data so far reflect otherwise.
In another sign that self-driving cars are on the distant horizon, Ford has been granted a patent for an “autonomous vehicle with reconfigurable seats.”
The highest paying bachelor's degrees -- both in starting salaries and mid-career incomes -- are mostly engineering and entirely STEM disciplines.
More:Blogs|News
Design News Webinar Series
8/13/2015 11:00 a.m. California / 2:00 p.m. New York
6/25/2015 11:00 a.m. California / 2:00 p.m. New York
6/24/2015 11:00 a.m. California / 2:00 p.m. New York
6/11/2015 11:00 a.m. California / 2:00 p.m. New York
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Aug 31 - Sep4, Embedded System Design Techniques™ - Writing Portable and Robust Firmware in C
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6 |  7


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2015 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service