It is certainly true that for many systems that utilize either hydraulics, or pneumatics, that using a manifold for some of the interconnects can provide a much more compact system that is both more reliable and less expensive. In fact, this holds true for both mass production and one-off systems, which is unusual. Of course the down side is that the system must be defined prior to the manifold being designed, since most manifolds are difficult to revise. But once a system is accurately defined a well designed manifold will usually provide a cost reduction, and almost always provide better reliability.
Mr. Fleischer, thank you for a good white-paper blog. You did not make it an advertisement for your company or products. Granted, the image shown was likely your product, but it in no way sold that product or even identified it. It was a good example of integrated system design.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.