I do agree with William K, in that high pressure is the way to carry more energy, but it should be H2 we are compressing in our vehicles for energy. Also made, is a good point about Americans and there overall challenge with mechanics like pumping gas. Devices are being designed with this in mind, to make it easy for people to 'pump' H2 gas into thier cars. It can be done, and is being done in Norway and Europe where they have re-fueling stations that... get this... humans actually manage to use these refueling stations on a daily basis.
AND... get this... you can run H2 gas in your ICE!!!!
Just change the timing to just after top dead center and run a new fuel line and mount an H2 canister where the gas tank used to be. You can still have your antiquated technology with hundreds of moving part and electronic devices and computers, and no one will care, because you will have the repair bills, and your car will spit out water instead of noxious fumes.
William, you obviously have never really looked under the hood of a car in the last 30 years if you think that an electric is more complicated than an ICE. about 5 moving parts vs. hundreds, and electronics on every system of that engine, all controlled by a computer. Talk about electronics? I once diagnosed a fuel supply problem in a JEEP grand cherokee. There were 5 different electronic devices involved in simply delivering fuel to the engine, and that wasn't including the injectors themselves and the electronics involved in gettint just the right mixture of gasses in each chamber. Your old fashioned desire to stick to old technology is not fooling anyone who is actually visiting reality. You fool very few with your constant drooling over antiquated technology.
Ever driven an electric golf cart? Do you think they need complicated drivetrains... Nope. They don't have gears at all. Will they go fast? Yup. (without a governor, they are incredibly and dangerously fast) I commonly drive golf carts, with only a few lead-acid batteries in them 15 miles on one charge (2 rounds). Granted... it's not Li with complicated cooling (which is not that complicated only). But it shows the simplicity of electric.
And... Don't put words in my mouth, I never said anything about a 25 mile electric, you (William K) just say that as smoke and mirrors to try and support and un-supportable point.
***The future of cars is H2 and fuel cells. Simple... clean... renewable... fast.
You can argue about batteries all you want, but I will take a tank of H2 and drive farther on one tankful using a fuel cell, than anything that takes gas of any form. This is the future, and the technology is here today.
@Charles: the way to compensate for the less energy per unit volume of CNG is to put more of it in the tank, often by means of going to a higher pressure. Instead of 2000 PSI, use tankes that run at 5000 or even 10,000PSI. One other possibility that I have not seen implemented is getting that gas to do some work as it expands, prior to combustion. Running the alternator with a turbine driven by the gas as it drops from the very high tank presure to the 300PSI injection presure is an interesting option.
Another option is reforming the natural gas mix into propane, which can be a liquid at more reasonable pressures. That may not be as easy as I wish, but it would work.
I agree, William K. There are barriers to the adoption of CNG, but it does show some promise. One of the barriers is its lack of energy per volume. Because it takes up so much space on board the vehicle, little cars are going to have a problem. Big trucks with more space for CNG tanks are better candidates for now. The good news is that it doesn't suffer from the cost barriers that EV batteries still face.
I'm not sure the auto execs have any understanding of what comes out of their mouths. These are the same folks who in part let the oil industry and the fear of socialized medicine bankrupt them; not just their limited understanding of technology.
My fellow Americans are stuck in the paradime where energy, (gas) is arguably everywhere. So simple logic tells you that if technology can make charging faster, (already being worked on) and ubiquitous, (not so much yet), pure electrics will surely overtake hybrids. However, the marketplace is about diversity and profit. Therefore as technology developes what may seem low cost now will not be so in the future. Besides, the proponents of big oil never cease to amaze me at how they like to bamboozle others out of our tax money. They want us to forget the tax payer funded environmental, health, and military costs associated with propping up their companies!
LNG, or more likely CNG, is another option that does make sense, but there are some real barriers to it's adoption as a major-use fuel in the US. The main problem is a lack of enough places to buy it. In addition, connecting a high pressure filling line is much more complex than sticking a nozzel into the filler tube. After seeing the problems that some drivers have with putting gasoline in their cars, LNG fueling would be a disaster for many people. It is a nicer to use fuel, but far worse to work with because of the much higher pressure.
Liquid Propane systems are similar, but the basic pressure in a system with liquid in equilibrium is a bit over 300PSI, which still is high-pressure enough to be a challenge to deal with.
The USA does have a lot of natural gas, and if we had the infrastructure it would have been a great choice.
Unfortunately the pure electric vehicle is NOT less complex than one with a standard IC engine. The motor may have fewer moving parts than a typical engine, but there is also a whole lot of complex electronics controlling that motor, plus the complex electronics to manage that $10K battery pack. ($10K is what the replacement will cost the owner, just wait and see). In addition there is the complex battery cooling system, which is not trivial, and also that regenerative electronic braking system. So while it may look like a simple collection of "boxes", the EV will be very complex. AND it is painfully clear to some of us that the mechanical portion of the engine is the most reliable part that there is on a car these days. MOST of the drive system failures are in the electronics. So please don't tell us how wonderful the electric vehicle with it's 25 mile range, (Air conditioning running) is. And why would I consider owning a car that I know will need a $10K battery replacement in five years?
The pure EV is certainly not ready for prime-time yet, but the ultimate goal is to have all cars running on batteries or capacitors with regenerative technology. The benefits of all electric are a no-brainer. They are less complicated, less moving parts, and depending on the energy source, can be entirely free of harmful emissions without regulations or expensive regulatory devices. Additionally, the processs of giving away billions of dollars/yr to foreign countries will end.
Battery density is doubling every 10 years and there is no reason to believe that anything will change. Lithium may be nearing it's peak density, but there is alwyays something to take it's place. When Ni Metal Hydride batteries reached thier peak density, Li took over. There will be something else tomorrow, even if our puny minds can't think of it today.
You are correct. I just wanted to make sure anyone else reading did not get the impression LNG would still wear valves these days. And it is true power is an issue in the US. But the US must catch up to Korea in LNG utilization. Oil is not good for the future of the US.
I was speaking to the advantages/disadvantages of that day. The trucks were designed for leaded gas (how many remember that?). Engine hardening hadn't even been considered at that point. And yes, I am aware that additives do the lubrication, much like the lead used to.
Korea has an extensive LNG infrastructure with LNG being an option on new vehicles. They don't have a problem with it, although they don't have the performance car culture that we do.
Last year at Hannover Fair, lots of people were talking about Industry 4.0. This is a concept that seems to have a different name in every region. I’ve been referring to it as the Industrial Internet of Things (IIoT), not to be confused with the plain old Internet of Things (IoT). Others refer to it as the Connected Industry, the smart factory concept, M2M, data extraction, and so on.
Some of the biggest self-assembled building blocks and structures made from engineered DNA have been developed by researchers at Harvard's Wyss Institute. The largest, a hexagonal prism, is one-tenth the size of an average bacterium.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.