HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
<<  <  Page 4/6  >  >>
edsparks3
User Rank
Iron
Re: Were the Boeing 787 Batteries Cooled Properly
edsparks3   1/28/2013 5:10:05 PM
NO RATINGS
Ougassing should have been observed during tests.  True, low atmospheric pressure might accelerate outgassing but the atmospheric pressure inside a (pressurized) commercial aircraft cabin is generally in the range of normal. 

I also think vibration could be the culprit.  (see my comment, above).  

Charles Murray
User Rank
Blogger
Re: Design Decisions
Charles Murray   1/28/2013 5:06:41 PM
NO RATINGS
That's a scary thought, Bill. It's not hard to imagine Boeing deliberately choosing cobalt oxide for the higher energy density. That's its chief advantage over other lithium-ion chemistries and it's the reason many engineers choose that chemistry. But as for their alleged lack of a cooling system: It's anybody's guess. I think a lot of engineers are still climbing the learning curve when it comes to all the lithium-ion chemistries.

edsparks3
User Rank
Iron
Overheating?
edsparks3   1/28/2013 4:57:15 PM
NO RATINGS
I can't believe Boeing would use a battery design that was not so carefully bench tested that there was absolutely no way it could overheat no matter what happened to the charging circuit and no matter how little cooling was available.    

On the other hand it is quite possible that due to vibration in the aircraft, the electrodes might go into a vibrational resonance allowing a couple to touch each other and cause an internal short.  This could be difficult - but not impossible - to simulate on the bench.  

But it might answer a lot of questions. 

 

Charles Murray
User Rank
Blogger
Re: Were the Boeing 787 Batteries Cooled Properly
Charles Murray   1/28/2013 4:53:43 PM
NO RATINGS
Very good point, Paul. Elton Cairns of the University of California agrees with you. He told us that the higher, colder altitudes were a detriment, not an advantage in this situation. Cairns, by the way, should know: He designed the PEM fuel cells for the Gemini spaceflights in the 1960s.

apresher
User Rank
Blogger
Boeing 787
apresher   1/28/2013 4:51:29 PM
NO RATINGS
Given the importance of this issue to Boeing, I would be shocked if it kept the 787 down until 2014.  That would be a major setback to a very high profile program.  But I also think their engineers will also be very careful in avoiding missteps in implementing a solution to this problem. Not an easy thing to have the world watching while you solve a complex technical issue.

Elizabeth M
User Rank
Blogger
Re: Batteries, not composites
Elizabeth M   1/28/2013 4:50:32 PM
NO RATINGS
Yes, Ann, good point! At least it seems like that part of the design is sound.

Elizabeth M
User Rank
Blogger
Re: Let's hope they get the chemistry right
Elizabeth M   1/28/2013 4:50:00 PM
NO RATINGS
Well, good! If that's the way it has to be, that's the way it has to be. Better to wait until the design is completely safe to fly the fleet than risk human life.

Charles Murray
User Rank
Blogger
Re: Let's hope they get the chemistry right
Charles Murray   1/28/2013 4:47:02 PM
NO RATINGS
They will get it right eventually, Liz. But it could take a while. Over the weekend, CNET published a story in which they, too, interviewed Donald Sadoway of MIT. Sadoway told them that the problems could keep the 787 fleet grounded until 2014.

http://news.cnet.com/8301-11386_3-57566066-76/boeing-battery-solution-may-keep-787-grounded-until-2014/

Ann R. Thryft
User Rank
Blogger
Batteries, not composites
Ann R. Thryft   1/28/2013 4:25:02 PM
NO RATINGS
At least no one's blaming this on the plane's use of carbon composites.

Elizabeth M
User Rank
Blogger
Let's hope they get the chemistry right
Elizabeth M   1/28/2013 2:52:53 PM
NO RATINGS
If this is true, then it's a bit scary to think this could happen again. Let's hope engineers get the battery chemistry right next time so something like this doesn't happen again and cause an even more dangerous situation.

<<  <  Page 4/6  >  >>


Partner Zone
Latest Analysis
Just how far has handheld gaming technology come? Let's take a look inside the Nintendo 3DS XL and find out.
Design, simulation, manufacturability, and prototyping: All of these phases are being pushed forward and progressively by underlying technologies.
Wal-Mart will hold its second Made in the USA Open Call July 7-8, at its headquarters in Bentonville, Ark. The event will be a repeat effort by the world’s biggest seller of consumer goods to increase the amount of US-made products it sells in Wal-Mart stores, in Sam’s Club members-only wholesale outlets, and on walmart.com.
From design feasibility, to development, to production, having the right information to make good decisions can ultimately keep a product from failing validation. The key is highly focused information that doesn’t come from conventional, statistics-based tests but from accelerated stress testing.
There’s a good chance that a few of the things mentioned here won't fully come to fruition in 2015 but rather much later down the line. However, as Malcolm X once said, "The future belongs to those who prepare for it today."
More:Blogs|News
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Jul 6 - 10, Building Raspberry Pi Controllers with Python
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6 |  7


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2015 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service