HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
Comments
View Comments: Newest First|Oldest First|Threaded View
Nancy Golden
User Rank
Platinum
leak notification
Nancy Golden   12/30/2012 1:14:33 AM
NO RATINGS
I think the individual alert mentioned is particularly important. Any leak detection system should have a mobile alert methodology, be it a cell phone app or something similiar (with built in redundancy) - otherwise whatever method being used for leak notification may go undiscovered until too late...

bobjengr
User Rank
Platinum
WATER LEAKAGE AND COST OF REPAIR
bobjengr   12/23/2012 5:23:09 PM
NO RATINGS
 

Emily--Excellent post.  One of my very first jobs after my military experience was as an engineer with a water heater manufacturer.   Leakage from the containment vessel was common place and there was never a week that went by where we did not receive complaints regarding tank leakage.  The most catastrophic were those leaks occurring in high-rise apartments.  Even a small leak can do significant damage to all areas below the problem.  Drip pans can hold only so much water and even those pans piped to a suitable drain can present a huge problem.  Oddly enough, the biggest problems occurred when repair men replaced heating elements and did not sufficiently seat the element seal against the tank itself.   Pin-hole leaks can also occur in weldments due to rust and dilatation of the vessel due to internal pressure.  A "warning system" would have been great to monitor internal pressure so that upstream solenoids could activate and shut off the water.  Even then, the contents of the tank could empty but that would not present the problem continuously running water would give. 

William K.
User Rank
Platinum
Re: Leak s
William K.   12/21/2012 2:46:44 PM
NO RATINGS
Sprinkler system leaks can certainly cause a huge inconvenience and quite a bit of economic loss. BUt the good news is that the technology to report them is fully mature and has been available off the shelf for quite a few years. The unfortunate fact is that because that hardware does not usually show a profit, (ROI), a lot of the MBA types will refuse to spend the extra money to mitigate a disaster.

That was the case when I worked at Delphi Diesel Aftermarket. The sprinkler pipe rusted through due to inadequate maintenance, and the resulting flood drenched the computer center for three days, damaging not only the server and records systems, but destroying a new "D" sized printer.

I suggested a sprinkler monitor package to the manager, who explained to me that since the expenditure would not add to the groups profits, he would not spend any money at all to add it to the existing fire and security system. So he left that building all set up for another flood, since the only maintenance done was to patch that particular leak. It seems that short-term thinking must be a major part of some MBA programs.

Cabe Atwell
User Rank
Blogger
Re: Leak s
Cabe Atwell   12/20/2012 1:33:37 AM
NO RATINGS
Complete environment sensing is starting to appear everywhere. Attending Sensor Expo earlier this year really showed the initiative in the area. Several companies are showing off their wireless sensor and monitoring services with much gusto. They all make you feel like water, pressure, heat and the like are out to destroy all you design and love. Hopefully, tech like this can be integrated in everything in the future. Every device, a smart monitoring device.



warren@fourward.com
User Rank
Platinum
Re: Leak s
warren@fourward.com   12/19/2012 7:57:34 PM
NO RATINGS
Yea, you're right.  You can't plan for everything.  I guess we design around the 90th percentile customer and let it go from there.

However, if we just waterproofed the water cooler...

NadineJ
User Rank
Platinum
Re: Leak s
NadineJ   12/19/2012 7:41:44 PM
NO RATINGS
Warren, your post makes me think of the phrase "penny wise, pound foolish"

warren@fourward.com
User Rank
Platinum
Leak s
warren@fourward.com   12/19/2012 2:53:19 PM
NO RATINGS
This got me to thinking about hurricane Sandy.  Maybe we should be giving more attention to hurricane and tornado prone areas when we supply or design equipment.  Perhaps this should be part of the design criteria, especially with critical systems.  I am not sure we can design for total submersion, but certainly we can design for damp.  Power stations, police and fire communicatons

Plus, when a sprinkler system goes off, there is no reason it should automatically destroy everything.

But, there is a cost involved.  And that may make it not worth it.



Partner Zone
Latest Analysis
The DDV-IP is a two-wheeled self-balancing robot that can deliver cold beverages to thirsty folks on hot summer days. A wireless RF remote enables manual control of the device beyond the act of self-balancing. All of the features of the DDV-IP result in an effective delivery vehicle while providing entertainment to the user.
Eric Doster of iFixit talks about the most surprising aspect of the Microsoft Surface Pro 3 teardown. In a presentation at Medical Design & Manufacturing Midwest, iFixit gave the Surface Pro 3 a score of one (out of a possible 10) for repairability.
Barnacles and mussels stay attached to ship hulls and rocks because of a very sticky protein glue they secrete, holding on for a long time even underwater. Researchers at MIT took mussel glue as inspiration -- and as an ingredient -- for engineering their own sticky waterproof adhesive.
Automation technology advances matched with expanded fracking and the growing urbanization of Asia, South America, and the Middle East, are fueling a boom in the automation industry.
3D printing is becoming a true manufacturing, not just prototyping, process facilitated by new materials.
More:Blogs|News
Design News Webinar Series
10/7/2014 8:00 a.m. California / 11:00 a.m. New York
9/25/2014 11:00 a.m. California / 2:00 p.m. New York
9/10/2014 11:00 a.m. California / 2:00 p.m. New York
7/23/2014 11:00 a.m. California / 2:00 p.m. New York
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Oct 20 - 24, How to Design & Build an Embedded Web Server: An Embedded TCP/IP Tutorial
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Next Class: 10/28-10/30 11:00 AM
Sponsored by Stratasys
Next Class: 10/28-10/30 2:00 PM
Sponsored by Gates Corporation
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2014 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service