When they say they are trying to make the wires and cables, are they inferring the use of a combination of plastics and sintering printing? That would be incredible to mix the two technologies, then you could truly create some awsome things.
Thanks, everyone--isn't this fun? I think it was only a matter of time once the industry achieved the ability to "print" flexible electronics via lithography, as DN has covered in the past: http://www.designnews.com/author.asp?section_id=1392&doc_id=249722
Wow, what will be available for 3D printing next--a human being?? :) I'm just kidding, of course, but this story is impressive! Printing sure has come a long way from dot-matrix, hasn't it? Look forward to more developments in this area and the potential for doing this commercially someday. If it progresses I forsee a whole new era of at-home inventions and armchair mad professors being inspired!
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Independent science safety company Underwriters Laboratories is providing new guidance for manufacturers about how to follow the latest IEC standards for implementing safety features in programmable logic controllers.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.