When they say they are trying to make the wires and cables, are they inferring the use of a combination of plastics and sintering printing? That would be incredible to mix the two technologies, then you could truly create some awsome things.
Thanks, everyone--isn't this fun? I think it was only a matter of time once the industry achieved the ability to "print" flexible electronics via lithography, as DN has covered in the past: http://www.designnews.com/author.asp?section_id=1392&doc_id=249722
Wow, what will be available for 3D printing next--a human being?? :) I'm just kidding, of course, but this story is impressive! Printing sure has come a long way from dot-matrix, hasn't it? Look forward to more developments in this area and the potential for doing this commercially someday. If it progresses I forsee a whole new era of at-home inventions and armchair mad professors being inspired!
Digital healthcare devices and wearable electronic products need to be thoroughly tested, lest they live short, ignominious lives, an expert will tell attendees at UBM’s upcoming Designers of Things conference in San Jose, Calif.
Designers of electronic interfaces will need to be prepared to incorporate haptics in next generation products, an expert will tell attendees at the upcoming Designers of Things conference in San Jose, Calif.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.