When they say they are trying to make the wires and cables, are they inferring the use of a combination of plastics and sintering printing? That would be incredible to mix the two technologies, then you could truly create some awsome things.
Thanks, everyone--isn't this fun? I think it was only a matter of time once the industry achieved the ability to "print" flexible electronics via lithography, as DN has covered in the past: http://www.designnews.com/author.asp?section_id=1392&doc_id=249722
Wow, what will be available for 3D printing next--a human being?? :) I'm just kidding, of course, but this story is impressive! Printing sure has come a long way from dot-matrix, hasn't it? Look forward to more developments in this area and the potential for doing this commercially someday. If it progresses I forsee a whole new era of at-home inventions and armchair mad professors being inspired!
With erupting concern over police brutality, law enforcement agencies are turning to body-worn cameras to collect evidence and protect police and suspects. But how do they work? And are they even really effective?
A half century ago, cars were still built by people, not robots. Even on some of the country’s longest assembly lines, human workers installed windows, doors, hoods, engines, windshields, and batteries, with no robotic aid.
DuPont's Hytrel elastomer long used in automotive applications has been used to improve the way marine mooring lines are connected to things like fish farms, oil & gas installations, buoys, and wave energy devices. The new bellow design of the Dynamic Tethers wave protection system acts like a shock absorber, reducing peak loads as much as 70%.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.