Mystery Signals showes up in nurological amplifiers.thruogh a shielded underground lab.Well thruogh the effects of detecting phonon modulation energy of the microwave radar thruogh phonon modulation detection.The effect is created by the presents of certion minerals possibly peveskite and rutile and silica and mana amounge others wich acts as a crystal modulater or detecter or both to creat the depth scan effect or in this case the signal being modified to go thruogh rock or an effect of detecting the tensors created by energy matter thruogh the demodulation effects of the crysals in the bedrock or ground.Possibly a gold indium mineral is invoved in the effect.But peveskite being a commenm mineral might be part of it or possibly a mineral gravel mix of some sort and possibly some other sort of outside energy as a sort of kicker for the efect.It is just a theory thruogh.
DesignNews should be embarrassed to print this pseudo-science. There is no such thing as scalar electromagnetic waves (except in very-specific situations which are not applicable here). If you follow the author's digital trail you'll find references to perpetual motion, space weapons, and fake medicine.
this is likely a joke based on Tesla folklore. The only so called scalar aka longitudinal E or B waves are special case modes inside a conductive waveguide, and even in that case are mutually exclusive. Either an E or B field can be longitudinal at one time. Furthermore, they do not leave the waveguide to the far-field, open space environment. Logical error in the article: If they will not act upon a condutor such as a Faraday cage, then they will not cause a current in your recieving equipment and will not go to the amp. Period. The E and B field in an EM trasmission are in phase in time, and 90 deg. to one another in space only ie. Flemming's rule of orthagonal orientation of E,B and physical Force.
Hello, anybody here remember their undergraduate electromagnetics classes? In a propagating EM wave in a lossless medium, E and B are in phase at all times. If there's a phase shift between them, it comes from gain or loss in the medium.
But of course there are lots of scalar waves known. The most common one is called "sound".
"Where does the inductive kick from an inductor or relay coil come from when the applied voltage is suddenly removed?"
Where does the current come from when a charged capacitor is suddenly short circuited? Collapsing electric field in this case, collapsing magnetic field in the inductor case. You certainly don't need a nebulous scalar space-time explanation for that...
The problem with this article is that the author has not determined the method of detection of this bi-polar signal. It simply went away and the author has "assigned" scalar waves" as a cause.
It has been my experience that RF signals having very high rise times in amplitude can drive apparently well shielded circuits crazy. My first experience with susceptibility of this sort was a particular UHF Motorlola handheld radio (MX300 series). These crystal controlled radios had a very abrupt transmitter turn on. Using one near just about any type of audio gear would generate a very noticeble "click". Later with the iDen (NEXTEL) and other TDMA products, it was observed that periodic clicking was heard in any nearby audio device or landline speaker phone .
I have no doubt, the microwave emenations cited by the author were the cause, however the detection phenomenon was left unexplored.
Could it have been so simple as a set/reset occuring in the overloaded op amp circuit hitting the rails? Perhaps the author was fooled by the triggering mode of his scope to beleive that it was a bi-polar signal?
I beleive this was simple case of the equipment being susceptible to the external microwave signals, that perhaps due to some "luck" were entering ductwork or cabling into the lab at just the correct instant of antenna position and pulse timing to deliver the full brunt of the magnetron. Perhaps it will return when the antenna rotation changes phase.
What should be the perception of a product’s real-world performance with regard to the published spec sheet? While it is easy to assume that the product will operate according to spec, what variables should be considered, and is that a designer obligation or a customer responsibility? Or both?
Biomimicry has already found its way into the development of robots and new materials, with researchers studying animals and nature to come up with new innovations. Now thanks to researchers in Boston, biomimicry could even inform the future of electrical networks for next-generation displays.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.