Hi Rob, I agree. The movement of the 2 robotic arms are very impressive. I thought the Dremel added a nice touch to the versatility of tools that can be attached to it. I wonder what robotic system is more cost competitive, ReThink Robotics "Baxter" or the ST Robotics Tandem Robot System? Very cool video!!
In theory at least it should not be that very difficult to link the two robots into one robotic program. Putting two 5-axis robots on a common base is an interesting concept, and it does reduce the concerns that would exist using two six-axis robots side by side. One thing that ceratinly will require a bit of extra attention is the much greater inertia encountered when swinging the common axis. Inertia is one of those things that tends to "get in the way" when programming robotic motions. Things that work perfectly at setup speeds suddenly have problems when running at production speeds. This is most obvious when grippers are unable to hold the part securly during high speed changes in direction. The result can be a part weighing several pounds being thrown quite a few feet.
The reason thatbthings seem to be different in production is that the robots move much faster than during any of the setup modes, and also that (it seems), the production staff tend to run robots toward their maximum capabilities. The very exciting experience that I had was a robot that I had done the path programming for flinging a six-pound transmission part across the work area. Fortunately we were not yet in a production mode, and the part harmlessly hit the floor twenty feet away. But it certainly could have ruined sombody's day. That incident was the result of the production motion speed being set much faster than it needed to be, and the gripper air pressure being lower than it should have been set at.
Festo's BionicKangaroo combines pneumatic and electrical drive technology, plus very precise controls and condition monitoring. Like a real kangaroo, the BionicKangaroo robot harvests the kinetic energy of each takeoff and immediately uses it to power the next jump.
Design News and Digi-Key presents: Creating & Testing Your First RTOS Application Using MQX, a crash course that will look at defining a project, selecting a target processor, blocking code, defining tasks, completing code, and debugging.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.