Looking at slide #3 of the 5th lecture, I'm reminded of the concerns you might have measuring a high-side shunt in a high voltage/high power circuit.
If you're measuring with a scope or data logger, you need to use 2 single-ended channels, one on each side of the shunt, because a scope or data logger normally have a grounded (earthed) chassis. If you try connecting the ground clip of a single-ended scope channel to the low side of a shunt, you could destroy the instrument due to high currents flowing from the UUT through the instrument's chassis to earth.
If the instrument's channels are differential or if you have a differential probe, then you can measure the voltage across a shunt with one channel of the instrument.
Floating a scope or data logger's power source is a bad idea if you're attmempting to make a high side shunt measurement with a single channel because the instrument's chassis could be at a high and dangerous voltage with respect to earth. One brush against the instrument and you get a potentially lethal shock.
rswanson: using an op amp to square an analog signal is fairly easy--check app notes from any major analog vendor, it's a classic circuit configuration. I know some early but still valid app notes from ADI show how to do it.
To all: remember, when you talk with an experienced vendor, they will raise issues you may not have even thought you needed to be worried about--but hey, it's worth listening to what they say, even if it may not be a concern of yours in the end, in your situation.
rswanson: by analog, I meant a basic op amp scaled to transform the input signal x the resistor size--you don;t really need to do a true multiplication of two unknown analog signals. And I think vendor like Microchip do make power-measurement ICs which combine analog and digital blocks in one easy-to-apply device.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Independent science safety company Underwriters Laboratories is providing new guidance for manufacturers about how to follow the latest IEC standards for implementing safety features in programmable logic controllers.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.