Jerry, that poly-cotton mix sounds like what I liked best for hiking clothes in my backpacking days. Cotton was supposed to be a no-no among backpacking enthusiasts because it takes so long to dry, either when wearing it, or when washing it at the campsite. But I found 100% polyester and other non-natural clothing to be too hot and sticky for comfort, no matter how it was made.
Just as bad is it melting on the skin then when you slap it to put it out it sticks to the hand and spreads sticking to the skin where it was buring/melting. Not a good way to go.
Living in Fla pure polyster is just too hot and uncomfortable in the summer. Though I really like rayon which is about the most comfortable cloth usually, slightly better than cotton and doesn't seem as flamable as polyester or nylon. A good 65% cotton, 35% polyster works fairly well and cuts the problems of pure cotton or pure poly.
That's an interesting story about polyester vs cotton and the flammability of natural vs synthetic materials. I remember as a kid in the 50s-60s hearing about the flammability of synthetic clothing material, which, I believe, is when many of the standards were developed for clothing material flammability.
Sounds like a waste product they are trying to find a use for. From the specs it's rreally just a filler pounded into dust so fine it won't show on the surface.
It's flamability is higher because it's so fine but the resin is more flamable so the point is moot. Wood actually is far less flamable than synthetic ones. The navy went to all polyster uniforms until they went up in flames regretfully with sailors in them so they switched back to cotton blends I believe.
Lou, I understand your POV on US materials sources. Actually Weyerhaeuser owns forests in various parts of the world and expects to source cellulose from them as needed. Forests that can be harvested for wood products in northern temperate zones (there aren't many in southern ones) are no longer as common as you might think, including in the US.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Independent science safety company Underwriters Laboratories is providing new guidance for manufacturers about how to follow the latest IEC standards for implementing safety features in programmable logic controllers.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.