Ann - thanks for offering the large size baths that are still being developed. I had no idea that 3D makers were developing apparatus that large. 6 meters square-? That's enormous. That's about 50 feet across diagonal; large enough to make a wingspan frame. Wow.
Chuck, I looked all over for build volume and printer size with no luck. The only clue is that it's designed to build components of large aircraft structures. I'm guessing several feet per side of build volume. Very large 3D printers exist in architectural apps for use with sand and soil and their build volumes can be 2m x 2m x 5m up to 6m x 6m x 2m, and even larger in the works.
@naperlou: Selective laser sintering typically doesn't yield a fully-dense part, so the mechanical properties would be significantly inferior to those of a forging. On the other hand, it has been shown that selective laser sintering followed by hot isostatic pressing can give mechanical properties equivalent to conventionally-processed titanium.
It seems like a good move for South Africa to go from an exporter of raw materials to a manufacturer of high-tech components. Other developing countries could benefit from this example.
Lou, the strength of the PM/sintered titanium powder metal parts produced by Dynamet has received approval from Boeing for use in structural aircraft parts, after a few years of testing. That news is pretty amazing on its own. The fact that Airbus has signed on to the Aeroswift aircraft structures project to help test selective laser-sintered titanium parts is another vote of confidence. It will be interesting to see what happens during that test phase.
Ann, this is interesting news. One question I would have is on the strength of the materials. In general, machined materials are stronger than injection molded materials. Of course, if the strength is enough for the purpose, then that is enough. Then the speed of manufactur is all important.
Engineers at Fuel Cell Energy have found a way to take advantage of a side reaction, unique to their carbonate fuel cell that has nothing to do with energy production, as a potential, cost-effective solution to capturing carbon from fossil fuel power plants.
To get to a trillion sensors in the IoT that we all look forward to, there are many challenges to commercialization that still remain, including interoperability, the lack of standards, and the issue of security, to name a few.
This is part one of an article discussing the University of Washington’s nationally ranked FSAE electric car (eCar) and combustible car (cCar). Stay tuned for part two, tomorrow, which will discuss the four unique PCBs used in both the eCar and cCars.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.