I agree that converting machined parts to die casting usually makes sense. Because die casting tools can be expensive, it is important to first do a pay-back analysis and see if the volumes justify this change over.
In many cases we use both processes during the life of the product. When the initial design is likely to change and we need to enter the market quickly, we may start with a machined part. Then, as the design becomes stable and production volumes increase, we plan for a smooth cut-over to die cast tooling.
In most cases, casting a part versus machining it from bar stock is a no-brainer. In my career, I've only come across one part that made more sense as a screw-machined part than as a die casting. In that case, the geometry of the part made it extremely easy to screw machine. Also, screw machining allowed the part to be made out of a much stronger wrought alloy. It wound up being an 80% cost savings (from $4 to about 80¢), along with a more than 50% increase in strength.
But this is far from the norm, and as this article shows, casting is almost always much cheaper. A more interesting comparison would be between die casting and powder metallurgy. It would also be worthwhile to compare different casting processes (die casting, semi-solid processing, permanent mold, investment casting, lost foam, etc.). In addition to cost, these processes also vary in terms of the mechanical properties and dimensional accuracy that can be achieved.
The 100% solar-powered airplane Solar Impulse 2 is prepping for its upcoming flight, becoming the first plane to fly around the world without using fuel. It's able to do so because of above-average performance by all of the technologies that go into it, especially materials.
With major product releases coming from big names like Sony, Microsoft, and Samsung, and big investments by companies like Facebook, 2015 could be the year that virtual reality (VR) and augmented reality (AR) finally pop. Here's take a look back at some of the technologies that got us here (for better and worse).
Good engineering designs are those that work in the real world; bad designs are those that don’t. If we agree to set our egos aside and let the real world be our guide, we can resolve nearly any disagreement.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.