Charles, I have wondered for quite some time as to how a system such as this works. In years passed I was tested every three months for BMI that involved percent body fat relative to muscle, etc etc. This is a program I volunteered for some time ago and is sponsored by one of the hospitals in our city. In the early days of this program, a "standard" method of calculating body fat was used; i.e. calipers. I'm told there is a significant improvement when using the scales and the medical practitioners now use only this method. Quite impressive and much less time consuming. This means you get the bad news and the lecture even sooner.
Well, Jdeslich, I'm impressed that a product that sells for $60 can offer such an analysis. It will be interesting to see if the wide range of medical devices being introduced these days will have inexpensive consumer counterparts.
So it goes in a scale that tells me my % body fat, please give me more details. I have a % body fat scale that cost me $59.95 not $100-$200. OK, so may the TI chip does something better, but why should I believe that with out some specifications?
I would be interested in learning a bit more about the algorithm used for this. At first look, it would seem that the body's resistance would change significantly by where you carried your fat. For example, it is more dangerous to have the fat be internal on / near the organs rather than on the outside of the muscle structure. In addition, would body composition throw this off?
I'm hoping this technology can modernize those nasty Height/Weight BMI charts. I have no problem with the Wii telling me I'm obese each morning, but for my 16 yo son, it's a different matter.
He has always been on the short side of average at each of his annual trips to the pediatrician (which prompted many a wonderful discussion of how to interpret statistical results) and hormones have kicked in overtime now that he is 16. He is in training for his 3rd degree black belt and has 8 hours of formal training each week in addition to his own workouts. The training has paid off and he has recently bloomed quite broad shoulders and chest and the six-pack abs that I never had. He had his height and weight checked at school along with all of the other kids and later received a letter informing him that his Height/Weight ratio has flagged him as being Obese. The letter also included pamphlets and information on how he should start exercising along with a list of health problems he will be facing in the future if he does not change his habits. He was pretty upset.
I'm all for facing the facts, but it would be nice if our measurement models produced facts, not fiction.
Hmmm. Still debating if this would be something that would make my list of to-buy gadgets although there is obvious benefit to knowing your body makeup. But then again, who needs the pressure of the constant reminder.
In all seriousness, given the fitness craze and our increasing focus on health and wellness, this chip puts really important monitoring capabilities well in reach of the average consumer and that's a good thing.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Independent science safety company Underwriters Laboratories is providing new guidance for manufacturers about how to follow the latest IEC standards for implementing safety features in programmable logic controllers.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.