With several brands of washers and driers, the reason that the service information is provided is that the parent company has no service people, only contractors who service all brands. So to support them they need to have that information available.They stash it inside the nachine because most folks are way to intimidated to open the cover, and many more simply throw out all of the papers that they don't understand, and also, many just throw out all of the papers that come with an appliance.
Whirlpool used to hide the servicer's instructions inside the control panel of their washing machines. Between these instructions and the timing diagram stuck to the back of the machine there was sufficient information to not only isolate to the field-replaceable unit (the $350 controller board) but to figure out which component on it (a $0.37 Triac) had failed. It did take a good bit of thinking, however.
Yes, those manuals are all over the place online. However, I've found that the forums often go into greater detail -- as in "Watch your knuckle when you undo this screw." But more to the point, the forums will let you know when it's important to also replace another part when you go to fix the part that failed.
Jon, thanks for that tip on where to find the service manual. That reminds me I once found a similar document inside a washing machine years back, also from Sears. I suspect they are right: most buyers are not engineers and/or tinkerer DYI types. Still, it would be nice to know ahead of time that you've already got the info and don't have to spend hours searching for the information online.
Good point, Rob. I was pleasantly surprised that the Sears washing-machine manual found inside the machine had so much detail. Probably created more for service people than buyers. The service tech also had a tablet computer of some sort that let him view documents and manuals.
You can also find these manuals online in many cases. You can find discussions of many of an appliance's problems in forums. I find that forums are often a better source to deal with a problem than a user manual.
When we had a sensor replaced on a Kenmore front-load washer, the service man removed the lower front panel to reveal a plastic pocket with a service manual that listed all the error codes, diagnostics, etc. Maybe Sears figured most buyers were not smart enough to look through the manual, find the problem, and try to handle it themselves. Anyway, manuals with error codes do exist, but sometimes they are hard to find. Ours is now safely in an appliance folder.
I had the same error code and plugged pump screen on my 8 year old Whirlpool a few months ago.
On my model there were two screws at the bottom corners of the front kick panel below the door. I removed the two screws. Removed the kick panel and the screen assembly was right there. Then turned the bayonet style cover from the screen assembly, no hoses to remove.
I pulled a wad of lint the size of a small rat out of the screen. Replaced everything and it has run several months without problems.
I, too, am disappointed that there is no list of error codes, troubleshooting suggestions, or mention of this screen in the literature that came with the washer.
As an added bonus, a foul odor that came from the laundry room vanished when I cleaned the screen.
Fifty-six-year-old Pasquale Russo has been doing metalwork for more than 30 years in a tiny southern Italy village. Many craftsmen like him brought with them fabrication skills when they came from the Old World to America.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.