Wikipedia has a good article about FRAM technology and it notes Ramton has worked with Texas Instruments for over 10 years, so that also might explain TI's interest in replacing high-power Flash memory and SRAM with FRAM. See: http://en.wikipedia.org/wiki/Ferroelectric_RAM.
Thanks, Jon, for that info. That makes sense. Back in the day when I covered memory, I used to wish I could write more about FRAM since it seemed like such a nifty technology for specific applications. That adjustable partitioning looks especially useful.
Hi,Ann. I bet TI put the FRAM in the MSP430 first because this MCU appeals to engineers who need to save as much power as possible. Because the FRAM operates from a 1.5-volt supply, it doesn't require a charge-pump circuit to produce the higher voltage needed by flash memory. That saves energy right away. According to TI, the FRAM section reduces memory power use by a factor of as high as 250 times. The FRAM also has faster throughput for read/write cycles and a very long life for such cycles. One additional capability--as noted already in a comment--gives programmers the capability to divide memory as they choose and adjust the partition as storage needs change. The entire memory-address range operates within the FRAM. So if you need only 1 kbyte of storage for temporary data, you can have 15 kbytes left for a program.
Thanks, tekochip and Chuck. I didn't realize that licensing issues were one of, if not the, major hindrance to wider adoption of FRAM. I'm still curious to know why TI put it in this MCU vs some other one.
MSP430 continues to push the state of the art in power consumption. Interesting that they chose the name "Wolverine," although it apparently did not help the University of Michigan during March Madness.
I believe using FRAM came from Ramtron finally being able to free up its licensing and other business concerns. I was fortunate enough to use a FRAM part recently and it performed exactly as described on the label. Other than the low current capability the technology also allows you to have a very free memory map, and interesting features like self-modifying code. TI really has something, rather than just introducing a faster/smarter micro, they truly have a new innovation.
Jon, interesting that the MSP430 Wolverine uses FRAM. I remember writing about this memory type years ago, but it never seemed to catch on in a big way although its benefits were obvious. Any idea if that's changed? Or why TI chose it for this specific MCU?
Engineers at Fuel Cell Energy have found a way to take advantage of a side reaction, unique to their carbonate fuel cell that has nothing to do with energy production, as a potential, cost-effective solution to capturing carbon from fossil fuel power plants.
To get to a trillion sensors in the IoT that we all look forward to, there are many challenges to commercialization that still remain, including interoperability, the lack of standards, and the issue of security, to name a few.
This is part one of an article discussing the University of Washington’s nationally ranked FSAE electric car (eCar) and combustible car (cCar). Stay tuned for part two, tomorrow, which will discuss the four unique PCBs used in both the eCar and cCars.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.