Thanks to our audience for attending today's DN Radio presentation on Integrated Motion Control and special thanks to our guest, George Gulalo of Motion Tech Trends. Keep in mind that the archive is available if you want to go back and review this session, or recommend it to a colleague. Again, thanks for participating. We hope this has been valuable and interesting.
Quite the contrary. The IMD really shines when the axis count is large due to the multipliacation of wiring and installation savings for each axis added to the system. It is a greater challenge for the IMD to penetrate the 1, 2 or 3 axis system because the advantages are not as signficant.
No I do not see most applications using IMDs. That said, we will see more motors using basic electronics on the motor such as the commutation electronics, even in simpler applications. However the electric motor/motion market has such a myriad of applications that users will continue to take advantage of the specific benefits of different technologies and system architecture to meet their needs.
Impact of DSP and fpgas......significant impact.....companies like Texas Instruments keep improving their offerings and are focusing some products on motion control. I have used an fpga for motion control and I can tell you the software and the help from the fpga makers makes their use simpler.
I expect to see wider support for popular industrial Ethernet networking protocols such as EtherNet/IP and PROFINET moving forward, but digital I/O is another alternative since many IMDs have their built-in I/O as well.
Depends on the application. SSI, a serial interface is still one of the more used protocols. Can and CanOPen that came out of the automotive industry is also well regarded. For highest end BiSS may be employed. The interface depends on the application
The streaming audio player will appear on this web page when the show starts at 2pm eastern today. Note however that some companies block live audio streams. If when the show starts you don't hear any audio, try refreshing your browser.
Engineers at Fuel Cell Energy have found a way to take advantage of a side reaction, unique to their carbonate fuel cell that has nothing to do with energy production, as a potential, cost-effective solution to capturing carbon from fossil fuel power plants.
To get to a trillion sensors in the IoT that we all look forward to, there are many challenges to commercialization that still remain, including interoperability, the lack of standards, and the issue of security, to name a few.
This is part one of an article discussing the University of Washington’s nationally ranked FSAE electric car (eCar) and combustible car (cCar). Stay tuned for part two, tomorrow, which will discuss the four unique PCBs used in both the eCar and cCars.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.