View Comments: Newest First|Oldest First|Threaded View
<<  <  Page 2/2
TJ McDermott
User Rank
Equal Time
TJ McDermott   3/17/2012 2:50:47 PM


Maybe it's time for Maytag or Whirlpool (or other appliance manufacturer) to pen an article for Design News.  Give them an opportunity for rebuttal, however I'd ask you to lay down firm ground rules.  They'll be writing to engineers and designers; simple (dumb) sales propaganda will not be tolerated.  If they can avoid that, you might find some interesting discussions result.

Ann R. Thryft
User Rank
Re: Things are not as they seem
Ann R. Thryft   3/16/2012 4:22:20 PM

The symptoms here sound a lot like those in an earlier Sherlock, where the culprit turned out to be a water fill level sensor for the rinse cycle, if I remember right. That earlier Sherlock had the same solution as our own washer's fill problem after rinsing. I admire the determination to find the solution in both of these, since the symptoms are apparently identical. It sure took us a few tries to find the right answer.

Rob Spiegel
User Rank
Things are not as they seem
Rob Spiegel   3/16/2012 2:24:53 PM
Yet again, our Sherlock Ohms notices something out of the corner of the eye that reveals the problem is not what it initially seems. Sherlock Ohms assumes nothing. Sherlock was called in to fix a washer, but when the water is not draining well, the problem may be with the drain path and not the washer.

<<  <  Page 2/2

Partner Zone
Latest Analysis
Designers of electronic interfaces will need to be prepared to incorporate haptics in next generation products, an expert will tell attendees at the upcoming Designer of Things Conference in San Jose.
According to a Randstad Engineering compilation of salary studies, engineering salaries are increasing beyond inflation, with employers paying to keep potential suitors away from their employees.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Design News Webinar Series
11/10/2015 11:00 a.m. California / 2:00 p.m. New York
10/29/2015 11:00 a.m. California / 2:00 p.m. New York
10/20/2015 8:00 a.m. California / 11:00 a.m. New York
12/2/2015 11:00 a.m. California / 2:00 p.m. New York
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Jul 6 - 10, Building Raspberry Pi Controllers with Python
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6 |  7

Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2015 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service