Jeff, I totally agree with you. A one time permanent fix as opposed to constant tweaking is always preferable. By the way tolerances are given for a reason. Once you have solved the problem to consistantly be, not only within tolerance, but exceeding by a factor of 4, any further messing around is a waste of time and money. Well done kyoshi.
Thank you for the compliment. It did work out as almost the ideal engineering solution, solving a long-standing product issue with no additional cost other than the initial programming of the Blohm grinder. The sensor based approach would be a fascinating project to try for an order of magnitude improvement over current best practice for "standard" machine tools.
As a control engineer, I am fascinated by the measurement approaches suggested. As a mechanical/project engineer, I am on the side that says if you can grind in the compensation on each part and you get what you want in terms of accuracy, you should. Any kind of sensor can eventually fail, connections fail, and sensors always needs to communicate with the controller. If you don't have those components in your design, you won't have the failure mode, you won't have to put them on the BOM, inventory or buy them. I think this is a great solution.
I appreciate your input. With the wide range of sensor technology available today in conjunction with inexpensive computational power a self-correction machine tool could obtain incredible levels of accuracy.
If you were using an angular sensor with a reference to the work surface you could make linear corrections to the position to compensate for the positioning error introduced by the angular motion of the structure. The linear correction of 5 ppm per arc second would be dependant on the the distance from the linear measurement reference for the Y-axis. Angular motions would still be introduced at the tool, possibly creating inaccuracy when large die sinking tools are used.
The machine in question is a relatively rigid structure, the angular deflections were extremely repeatable under a range of operation conditions. Real time measurements would be more expensive (and less effective) than mechanically compensating for the underlying structural deflections.
The workpiece is attached to the table, the diesinking form tool is attached to the bottom of the Z-axis. Angular errors, positioning errors, straightness and squareness errors will all produce unwanted deviations from "perfect" in the finished workpiece. Improving the machine accuracy will improve the accuracy of the workpiece, measuring the errors will only tell you how much error you are introducing into the workpiece.
If I understand it correctly, you have one reference surface and then the other that changes its orientation. You can use a unit called EZ-TILT-5000, that reads two sensors and can provide you with individual angular orientation of each sensor and also the differencial. This way you can always see the actual deviation of the required surface in reference to the standard.
It looks like a great sensor, but I am not sure how you would compensate for the angular error in this example. The angular machine deflection is referenced to the machine table, and a mechanical compensation is necessary to maintali Z-axis squareness to the machine table (and workpiece).
The first Tacoma Narrows Bridge was a Washington State suspension bridge that opened in 1940 and spanned the Tacoma Narrows strait of Puget Sound between Tacoma and the Kitsap Peninsula. It opened to traffic on July 1, 1940, and dramatically collapsed into Puget Sound on November 7, just four months after it opened.
Noting that we now live in an era of “confusion and ill-conceived stuff,” Ammunition design studio founder Robert Brunner, speaking at Gigaom Roadmap, said that by adding connectivity to everything and its mother, we aren't necessarily doing ourselves any favors, with many ‘things’ just fine in their unconnected state.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.