Yes, the technology that's getting developed in one of those gov/industry/university projects works to grab winds that are not pointing in such a way as to spin stationary blades while at the same time optimizing the spin by adjusting the blade positions.
Aldo, thanks for your input on the complex algorithms required to optimize the operation and performance of components such as blades. Beth, I'd also think that motion sensors and accelerometers would probably also be involved.
Funny you should raise the issue of idle turbine blades. We have one fairly large wind turbine located in my town and I have say, most of the time I drive by it, it sits idle. We live in a coastal community and the wind turbine is fairly near a pretty good size river that flows directly into the Atlantic. Needless to say, coastal winds are a big deal here. Again, despite the proximity to all this, the blades are spinning far less than I ever thought they would.
That said, I imagine the turning of the blades to adapt to wind direction has to be where it's at for future development. I would guess in addition to CAD and CAE software, intelligent sensors, embedded software, and some sort of accelerometer technology would be critical, perhaps??
Hi, this is interesting for the energy industry because wind power is highly expected to become a major source or energy for many countries. Nowadays it is very attractive for investors to invest in a wind power plant when the resource is good instead of investing in a fossil fuel utility plant. I have studied new methods for optimization of turbine components like blades by using programming techniques like genetic algorithms combined with CAD/CAE software to increase efficiency of energy conversion, reduce size and weight of components and making the technology more affordable. More information about genetic algorithms used for wind blade development can be read in the following link: http://mozart.dis.ulpgc.es/Gias/Publications/mendez-greiner.pdf
I would also expect that reducing the weight of the blades could help boost overall performance. With the emphasis on offshore installations and much larger turbines, the weight of the blades is a huge factor for design, installation and maintenance.
Blade control is one of the areas where potential technology developments could improve the efficiency of wind turbines. Today, most turbines are using independent pitch control where each blade is independently controlled by a servo actuator. But all of the blades respond to the same command as they go through their cycle. Individual pitch blade control provides real-time feedback from blades or monitoring devices, and one approach is to embed sensors into the blades for real time load feedback. The system closes the loop at the turbine level using that feedback to significantly reduce the load variation from blade to blade. The result is an ability to handle peak gusts better and more quickly.
Oh, I get it. I didn't realize you meant not only getting the most out of a particular gust of wind, but keeping them going in the first place, so they are turning whenever there's wind instead of staying idle just because there's wind but not going the right way.
The Smart Emergency Response System capitalizes on the latest advancements in cyber-physical systems to connect autonomous aircraft and ground vehicles, rescue dogs, robots, and a high-performance computing mission control center into a realistic vision.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.