So far the tools to control the blades for optimum turn is still on the drawing table. Yet I can certainly see the need for it after driving by so many turbines that are sitting idle just because the wind isn't blowing in the right direction. I would imagine we'll see a ton of development in wind in the coming years.
Thanks for the input. Rob. I know you've written about alternative energy sources like wind turbines, which are relatively new to me. Making them larger makes sense, but solving the weight-to-size ratio problem sounds pretty major. I bet the CAE software has made a big difference there. And I bet it's also key in figuring out how to design the blades that optimize wind, as you describe.
Nice article, Ann. Turbines keep getting more efficient and more effective. Another area of research is going to create turbine blades that are optimized to gain the most of the wind. The blades are controlled to change position as the wind direction and velocity changes, the goal being to get the most efficient use of the wind at all times.
Sounds like the ability to design blades and other components using composites is probably highly dependent on that simulation ability. No doubt this is also a major contributing factor to why there's a big increase in the use of composites in so many apps, not just the fact that there are so many more versions of composite materials to choose from. Thanks for the info.
Absolutely Ann, there issues around aerodynamics and airflow as well as structural integrity and reduction in weight--all key factors that can be explored and optimzed in the virtural world with FEA, CFD, and other CAE software. With simulation, designers of these wind turbine blades can test out many more design options virtually, prior to investing the money to build physical prototypes, which is a huge expense, especially with the growing size of these blades and with all the new composite materials, which are costly.
Thanks Beth for weighing in about the simulation software used for wind turbine blade design. I would think that designing blades, root rings and other components of wind turbines must be quite a challenge, especially in alternative materials. It only makes sense that software is part of the design engineer's toolkit for making bigger blades possible.
Seems like the Bayer MaterialScience technology has a lot of promise in terms of promoting wind turbine blade design. Along with materials, simulation software is also playing a huge role in perfecting wind turbine blade design and for pushing for much bigger, higher capacity blades. Click here to read about Sandia National Labs' research project effort to build a 100m blade, which in a traditional three-bladed turbine design, would take up a footprint of about two-and-a-half football fields in size. The massive blade is aimed at off-shore turbines.
Although plastics make up only about 11% of all US municipal solid waste, many are actually more energy-dense than coal. Converting these non-recycled plastics into energy with existing technologies could reduce US coal consumption, as well as boost domestic energy reserves, says a new study.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.