HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
REGISTER   |   LOGIN   |   HELP
<<  <  Page 11/11
tekochip
User Rank
Platinum
Company to watch
tekochip   3/6/2012 8:51:07 AM
NO RATINGS
These last few years I've been using an electric bicycle for my daily commute and converted my lawn mower to solar (the idea of a green lawn mower just seemed obvious).  The efficiency of motors and motor controllers have advanced to the point of being very well-suited for transportation but energy storage is still lagging.  The promise of doubling the capacity of the current battery systems would place the energy storage at the same technological level as the power plant and make e-vehicles practical.  I couldn't help but notice the very cautious tone of the article, though.  There are lots of questions for the future; can the cell produce high drain and deep cycle life without damage, and can the manufacturing process sustain high production levels.  This is a company to watch in the future.


Beth Stackpole
User Rank
Blogger
It's all about continuous learning
Beth Stackpole   3/6/2012 8:06:46 AM
NO RATINGS
Love to hear these tales of startups with a new low-cost, high-energy density battery story to tell. Given all the research and R&D dollars being poured into electric car battery research, my guess is we have to be nearing the point where a lot of the early disappointments either have evolved or are being replaced with new startups and technologies that are much closer to the mark of advancing the cause. Afterall, each failure or disappointment points up valuable lessons learned that can then be applied to the next round of developments that get battery density and cost closer to where we want to go.

ervin0072002
User Rank
Gold
We are moving forward?
ervin0072002   3/6/2012 6:51:17 AM
NO RATINGS

This is good to hear. The technology is badly needed in our society. My sole question is: can our grid handle a large percentage of cars going electric? All around the USA I see a steady increase in the cost of electricity. Am I the only one that is itching to invest in solar and electric generation in general? Another application this can be put into is off the grid Energy storage. Off the grid Inverters are cheaper. Emergency power might act as secondary storage for the grid too. I honestly see the future grid requiring Grid-tie solar or wind systems to come with a certain rating of battery power. Eventually the grid will become too erratic for our slow turning turbines to match.

<<  <  Page 11/11


Partner Zone
Latest Analysis
Today's robots should be respected, and humans should be wary of their growing skills and sophistication. Quite simply, robots are better than us in a lot of ways. Here are 10 of them.
3D printing has met up with drones in a 3D-printed UAV. University of Sheffield engineers printed the prototype drone in 24 hours from ABS plastic using Fused Deposition Modeling.
Product design is changing with advances in technology and outsourced manufacturing. The Art of Product Design spells out the future of design engineering.
AMD is set to launch the industry's first 16 GB workstation graphics card -- the W9100.
Samsung's 5th-generation Android-based Galaxy smartphone includes a fingerprint scanner, updated camera and display, and water/dust resistance.
More:Blogs|News
Design News Webinar Series
3/27/2014 11:00 a.m. California / 2:00 p.m. New York / 7:00 p.m. London
2/27/2014 11:00 a.m. California / 2:00 p.m. New York / 7:00 p.m. London
12/18/2013 Available On Demand
11/20/2013 Available On Demand
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Apr 21 - 25, Creating & Testing Your First RTOS Application Using MQX
SEMESTERS: 1  |  2  |  3  |  4  |  5


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Next Class: April 29 - Day 1
Sponsored by maxon precision motors
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Copyright © 2014 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service