HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
Page 1/4  >  >>
Ann R. Thryft
User Rank
Blogger
Re: Smart Paint In Use?
Ann R. Thryft   4/18/2012 12:35:14 PM
NO RATINGS

gsmith, this paint was developed in the UK, not the US, and when I reported this it was in a prototype stage, so I doubt if it's being used here. However, some of the comments in the message board below list a few articles by Charles Murray on various US attempts at detecting faults in similar structures using wireless sensor networks.


gsmith120
User Rank
Platinum
Smart Paint In Use?
gsmith120   4/14/2012 6:03:57 PM
NO RATINGS
Ann, do you know if this paint is currently being used on any bridges in the US?  I can't remember the stats or which bridge, when the US last bridge collapsed a report indicated there were a lot of bridges that needed repair.  This type of paint even if it is just in a testing phase would serve a good purpose.  I would be most interested in the any report that would be created from data collected at the various test sites.

 

Ann R. Thryft
User Rank
Blogger
Re: Self-charging batteries
Ann R. Thryft   2/29/2012 12:18:55 PM
NO RATINGS

Thanks for the link, Chuck. That goes to the message board for the story. Here's the direct story link:

http://www.designnews.com/document.asp?doc_id=232087


Charles Murray
User Rank
Blogger
Re: Self-charging batteries
Charles Murray   2/28/2012 7:39:18 PM
NO RATINGS
Here's one more link to a story about the use of sensor networks in bridge inspection.

http://www.designnews.com/messages.asp?piddl_msgthreadid=240560

 

Ann R. Thryft
User Rank
Blogger
Re: Self-charging batteries
Ann R. Thryft   2/23/2012 2:39:27 PM
NO RATINGS
 

Chuck, thanks for the links and info on this form of energy harvesting. It's also interesting to hear that bridges are already being built with wireless sensor networks for detecting structural problems. This research was done in Scotland, though, and the study makes it sound like they don't have those installed there for remote fault detection.

 

Rob Spiegel
User Rank
Blogger
Re: Self-charging batteries
Rob Spiegel   2/21/2012 2:25:45 PM
NO RATINGS
That makes perfect sense, Chuck. Depending on how well the current sensors are working, using the paint solution could be a cost reducer.

Charles Murray
User Rank
Blogger
Re: Self-charging batteries
Charles Murray   2/21/2012 12:01:30 PM
NO RATINGS
Rob: Bridges are now being wired with sensor networks that detect structural problems. I wonder if the smart paint could work with the networks.

http://www.designnews.com/document.asp?doc_id=232087

 

Rob Spiegel
User Rank
Blogger
Re: Self-charging batteries
Rob Spiegel   2/21/2012 11:02:34 AM
NO RATINGS
Thanks for the links, Chuck. I see you were writing about this back in 2009. One interesting aspect is that some of this is made possible because of lower power needs from sensors and other devices. So the advances is not just greater ability to harvest energy, but also that not as much energy is required.

Charles Murray
User Rank
Blogger
Re: Self-charging batteries
Charles Murray   2/17/2012 6:15:39 PM
NO RATINGS
Rob, here's another article that addresses the use of vibration for energy harvesting.

http://www.designnews.com/document.asp?doc_id=228263

And here's one that looks at RF to dc.

http://www.designnews.com/document.asp?doc_id=230198

 

Ann R. Thryft
User Rank
Blogger
Re: Self-charging batteries
Ann R. Thryft   2/16/2012 2:45:38 PM
NO RATINGS
 

The fan is designed specifically for woodstoves. There are a few different brands, but they seem to be practically identical. They all come in two sizes and I have the "large" size. The fan is designed only to distribute the heat in one room; it's not powerful enough for more than that. Most heat sources aren't, except for whole-house forced air furnace systems. I've always thought those were unnecessarily and ridiculously complex and expensive. 

The woodstove is our major source of heat. It's unhelpfully located at one end of the (smallish) house's long axis (and not relocatable without great hassle and expense), so two small ceiling fans distribute the heat farther. But the farthest rooms tend to get cold in winter. About half way from the stove is a forced air propane wall heater for backup, but I rarely use it except on winter mornings before the woodstove cranks up. I hear that Vermonters adhere to the same principal as Scots and Brits: "put on a sweater!" Sounds like us here at my house.

 

Page 1/4  >  >>


Partner Zone
Latest Analysis
Melissa Cavanagh of 3DP Unlimited talked to Design News about the company’s large format 3D printer, during Medical Design and Manufacturing Midwest.
The DDV-IP is a two-wheeled self-balancing robot that can deliver cold beverages to thirsty folks on hot summer days. A wireless RF remote enables manual control of the device beyond the act of self-balancing. All of the features of the DDV-IP result in an effective delivery vehicle while providing entertainment to the user.
Eric Doster of iFixit talks about the most surprising aspect of the Microsoft Surface Pro 3 teardown. In a presentation at Medical Design & Manufacturing Midwest, iFixit gave the Surface Pro 3 a score of one (out of a possible 10) for repairability.
Barnacles and mussels stay attached to ship hulls and rocks because of a very sticky protein glue they secrete, holding on for a long time even underwater. Researchers at MIT took mussel glue as inspiration -- and as an ingredient -- for engineering their own sticky waterproof adhesive.
Automation technology advances matched with expanded fracking and the growing urbanization of Asia, South America, and the Middle East, are fueling a boom in the automation industry.
More:Blogs|News
Design News Webinar Series
10/7/2014 8:00 a.m. California / 11:00 a.m. New York
9/25/2014 11:00 a.m. California / 2:00 p.m. New York
9/10/2014 11:00 a.m. California / 2:00 p.m. New York
7/23/2014 11:00 a.m. California / 2:00 p.m. New York
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Oct 20 - 24, How to Design & Build an Embedded Web Server: An Embedded TCP/IP Tutorial
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Next Class: 10/28-10/30 11:00 AM
Sponsored by Stratasys
Next Class: 10/28-10/30 2:00 PM
Sponsored by Gates Corporation
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2014 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service