Cool looking engine and the creator seems to have done a solid job engineering a solution that can work around temperature swings. What exactly did this stirling engine do in terms of running a scupture? It wasn't evident from the video.
This is a case where I agreed to design and build a functioning prototype engine and the artist could modify it artistically to do whatever he wanted. I explained that it wouldn't generate enough power to really do anything except run. The artist can do more interesting things with the colors, finishes, and some of the shapes, particularly the flywheel and displacer. I get a kick out of watching the utilitarian prototype quietly running. I'm curious to see what the artist comes up with for the finished sculpture too.
Thanks, Doug. Fantastic answer. I was musing about what the artist could do with all of the extra power generated by the Sterling engine and then I recalled the efficiency of the Sterling is barely enough to keep itself in motion. I'm not sure what the artist will augment, but your creation is a fine piece of performance art as it is... =]
We have a similar installation here in Albuquerque, just before I-40 comes into the city. Up on the canyon hills there's a sculpture that looks like a large steel flower. Next to it is a solar-powered light that shines the colors of the rainbow one by one. So the metal flower turns blue, then green, etc. Needless to say, when the sky has been overcast for a few days, the motor and light don't work. But it's rarely overcast for long here, so most of the time it works. There must be a light sensor connected to the motor, since it is idle during sunlight.
Digital healthcare devices and wearable electronic products need to be thoroughly tested, lest they live short, ignominious lives, an expert will tell attendees at UBM’s upcoming Designer of Things Conference in San Jose, Calif.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.