My mechanic showed my some electronics from inside a fuel tank. Two wires have rubbed on each other and fused together (probably the subject of a made by monkeys column.) The customer complained that the fuse kept blowing so our repairer replaced it with a self-resettable fuse in a 40 amp circuit. It takes little imagination to figure out the wires will heat up inside the fuel tank and solve the customers problems for them PERMANTENTLY. Maybe this would be a case of repaired by murderers!
The second item of re-engineering by monkeys is a transformer replacement in a filament power supply running 480 volts, using a triac as the regulating element. It has a 480 primary transformer with a 32 volt CT secondary to supply the regulating circuitry. This is not a standard item anywhere so the repairer figured why not just replace the failed transformer with a 230 volt primary 64 volt secondary. Fine in theory except the matter of insulation, and the matter of 480 creating arcs that are hard to quench. There is also the fact that this unit is controlled through low voltage control circuits for operator interface, any of which might suddenly break down when 480 volts shorts through to the secondary side.
These fellas must have got their re-engineering degree from Shade Tree University.
Lantronix Inc. has expanded its line of controllers for sensor networks with the release of a rugged controller that improves management of automation systems used in a number of industries, including manufacturing, oil and gas, and chemicals.
Inspired by the hooks a parasitic worm uses to penetrate its host's intestines, the Karp Lab has invented a flexible adhesive patch covered with microneedles that adheres well to wet, soft tissues, but doesn't cause damage when removed.
A quick look into the merger of two powerhouse 3D printing OEMs and the new leader in rapid prototyping solutions, Stratasys. The industrial revolution is now led by 3D printing and engineers are given the opportunity to fully maximize their design capabilities, reduce their time-to-market and functionally test prototypes cheaper, faster and easier. Bruce Bradshaw, Director of Marketing in North America, will explore the large product offering and variety of materials that will help CAD designers articulate their product design with actual, physical prototypes. This broadcast will dive deep into technical information including application specific stories from real world customers and their experiences with 3D printing. 3D Printing is