i would strongly disagree with the findings. Obviously dialling, texting, operating GPS units, or "lighting up a fag", are all extremely dangerous (and foolhardy) actions when you are supposed to be concentrating on your driving. But I have followed plenty of drivers who are merely carrying on a conversation with a phone to their ear,* and their driving is extremely erratic: speed variations, and "drifting" from one side of their lane to the other, seem to be the most common faults.
It beggars belief that our state of Victoria, (in Australia), has outlawed the use of hand-held phones in vehicles, yet it is ok to have GPS units**, car stereos with handheld remote controls, DVD players etc. (and cigarette lighters)
I'm not sure of the scientific reason, but there appears to be some sort of "proximity effect" when there are passengers in the car. They seem NOT to pose a major distraction for the driver.***
Having taken lessons in light aircraft, I found it quite comfortable talking to the Instructor while controlling the aircraft, and had no difficulty maintaining full concentration. It was a different matter when I had to make Radio calls. Maintaining control while trying to absorb instructions from a dis-embodied voice, and relaying information back to ground controllers required a much higher level of concentration.
If it were up to me, all electronic goods apart from the car stereo would be illegal in motor vehicles.
Chuck Solide
Melbourne, Australia
* Notwithstanding the fact that it is illegal !
** GPS units are merely contributing to the "Dumbing Down" of the population, are no substitute for the ability to "navigate", and have caused tragic deaths because they aren't always correct !
*** This does not apply to many ethnic groups (and individuals) who have the dangerous habit of turning to face their passengers to carry on their conversations, both orally and with hand gestures. (this is not racist comment, merely an observation, and I assume it has more to do with cultural influences than anything else)
Yes, kids are a major distraction, especially when you have a little one crying or older ones fighting. And you're right, that never gets mentioned. That's probably because it's an organic distraction and thus it can't be controlled in the same way that the use of cellphones and be restricted legally.
Whenever distractions are discussed, kids are seldom mentioned. Truth be told, though, kids are probably the biggest possible distraction. Having them buckled into car seats definitely helps, but I always wonder how drivers managed in the 1950s, when kids weren't buckled and families were bigger. Can you imagine driving a car with six unbuckled kids in it? I'd consider jumping out the window.
So consoles may be the new texting. I would think it is certainly worth looking into. Glad to hear that all aspects of driver distraction are included. Hope they include my favorite. Coming back from the store, I refilled a kid's tippy cup from a half gallon of milk while driving. I got pulled over for swerving. The cop let me off with the warning that I need to pull off the road when I refill the tippy cups.
I believe we will hear more about this in the next year or so. The University of Iowa has a massive $60 million driving simulator in which they plan to test all kinds of driving distraction issues. I hope center consoles will be among their studies.
That makes the dash electronics would become a problem if drivers are messing with them while driving. I haven't heard much about this distraction. All of the focus seems to be on texting and talking on cellphones. Any distraction could be dangerous.
Rob: There's a breed of center consoles that has been evolving over the last few years that do a few things that dashboards generally didn't do seven or eight years ago. These new systems allow users to connect to devices that are brought in from outside (smartphones, iPods, GPS) and use them through the center console. They aren't new per se, but the distraction problem associated with them is growing more noticeable.
In my opinion, Jack, the nested menus that you refer to are some of the worst offenders because they call on us to keep our eyes away from the road longer.
I would guess these new dashboards would be a major distraction problem. It's not something I've heard anything about -- regarding safety. Is this type of super sophisticated dashboard brand new?
Even worse, Charles, is the fact that things are getting buried 2 or three levels deep. I'm not talking about some setup type functions either. These are things that used to be buttons on the dashboard.
By experimenting with the photovoltaic reaction in solar cells, researchers at MIT have made a breakthrough in energy efficiency that significantly pushes the boundaries of current commercial cells on the market.
In a world that's going green, industrial operations have a problem: Their processes involve materials that are potentially toxic, flammable, corrosive, or reactive. If improperly managed, this can precipitate dangerous health and environmental consequences.
With LEDs dropping in price virtually every year, automakers have begun employing them, not only on luxury vehicles, but on entry-level models, as well.
From Dell / Intel® New Paradigms in Design Work Scott Hamilton, vertical market strategist for Dell Precision workstations, 5/2/2013 3
Early in my career, I worked as a draftsman and remember the days of drawing on vellum with numbered pencils and Mylar with plastic lead. This was a fun experience in the sense that I ...
I've been using workstations for more than 10 years and love finding ways to get more performance from my system. With demanding professional applications that require more power each ...
A lasting memory from my first job as an engineer in an auto assembly plant is standing on hard concrete at six in the morning, vending-machine coffee clutched in hand, listening to ...
A quick look into the merger of two powerhouse 3D printing OEMs and the new leader in rapid prototyping solutions, Stratasys. The industrial revolution is now led by 3D printing and engineers are given the opportunity to fully maximize their design capabilities, reduce their time-to-market and functionally test prototypes cheaper, faster and easier. Bruce Bradshaw, Director of Marketing in North America, will explore the large product offering and variety of materials that will help CAD designers articulate their product design with actual, physical prototypes. This broadcast will dive deep into technical information including application specific stories from real world customers and their experiences with 3D printing. 3D Printing is
To save this item to your list of favorite Design News content so you can find it later in your Profile page, click the "Save It" button next to the item.
If you found this interesting or useful, please use the links to the services below to share it with other readers. You will need a free account with each service to share an item via that service.
Tweet This
3 
