Jerry dycus
User Rank
Not new
Jerry dycus   1/3/2012 9:34:36 AM

           This tech isn't new as it's been done for over 50 yrs, just rarely in cars because gas was so cheap.  Many used the old DynaStart generator/starter unit back in the 40's.

          I fail to see why instead all cars don't have the flywheel as the starter/alt that can also be used for regen/braking and acceleration boost at little extra cost if any.  By joining the 3 saves copper, alum casings, pulleys, belts and their losses, etc,

             And savings from a smaller engine could make it even cost less while cutting fuel use 15-20%.

User Rank
Longevity Issues
Walt   1/3/2012 12:13:14 PM

For a fuel savings of only 3~5% - and then only in city driving – I'd hate to add the longevity and reliability issues likely to occur:

Stopping an ICE generally causes a short-term, but fast and significant increase in case temperature.  The only prevention of this is to continue the flow of coolant through the engine, plus the radiator fan in many cases.  Now the electrical system must support the coolant pump at every stop.  It must also ensure that over-cooling does not occur to reduce temperature changes, which shorten the life of the internals of the ICE.

I'd also be surprised if even an improved starter and flywheel could put up with engine starts at every stop without significantly reducing the lifespan.  It seems this should be accomplished via the power train.  This would only be feasible in a hybrid electric or starting from each stopped position would include the delay of the initial stabilization of the ICE after startup.

For a person that expects 200K~300K miles of good service from a vehicle, these look like shaky configurations for this small level of fuel efficiency.


Partner Zone
Latest Analysis
General Motors is putting an off-road twist on hydrogen fuel cell technology with an imposing new pickup demonstrator called the Chevrolet Colorado ZH2.
Fine powder printing of industry-standard metal and ceramic powders with a grain size of less than 10 microns is now available from industrial 3D printer maker ExOne for its Innovent printer.
At ARM TechCon 2016, CEO Simon Segars will discuss how he sees billions of devices scaling to trillions as IoT applications proliferate. We know it’s happening. How do we prepare?
The term “autopilot” is now at the heart of a growing debate between Tesla Motors Inc. and Germany’s Federal Motor Transport Authority.
A make-your-own Star Wars Sith Lightsaber hilt is heftier and better-looking than most others out there, according to its maker, Sean Charlesworth. You can 3D print it from free source files, and there's even a hardware kit available -- not free -- so you can build one just in time for Halloween.
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Oct 10 - 14, Embedded System Design Techniques™: Getting Started Developing Professional Embedded Software
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6 |  7 | 8 | 9 | 10

Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Next Course September 27-29:
Sponsored by 3M
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Technology Marketplace

Copyright © 2016 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service