Took a quick check back at the spec sheet for the ProJet 1500. Here's what it says in terms of size of parts/performance.
Max Build Size (XYZ) 6.75 x 9 x 8 in (171 x 228 x 203 mm) Native Resolution (xy) 1024 x 768 DPI Layer Thickness Standard Mode 0.004 in (102 μm) High speed Mode 0.006 in (152 μm) Vertical Build Speed Standard Mode 0.5 in/hour High speed Mode 0.8 in/hour (VisiJet® FTI-Zoom material only)
@jfrisbie: You are correct and thanks for pointing out my mistake. The vertical build speed is .8 inches per hour, not .08 inches an hour. The official spec sheet says that in high-speed mode, the unit prints at 0.8 in/hour using VisiJet FTI-Zoom material only.
I believe this is .8 inches per hour. As we run two of their older machines this would be slightly faster build rate than what we see. Although the build speed depends on the layer resolution that you choose. I find that going from .010 layer thickness to .007 adds about 40% to any given parts build time.
Digital healthcare devices and wearable electronic products need to be thoroughly tested, lest they live short, ignominious lives, an expert will tell attendees at UBM’s upcoming Designers of Things conference in San Jose, Calif.
Designers of electronic interfaces will need to be prepared to incorporate haptics in next generation products, an expert will tell attendees at the upcoming Designers of Things conference in San Jose, Calif.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.