I didn't install the original pump so I assume the pipe was carbon steel. I know it wasn't stainless steel. The pump body was cast iron and we run polyethylene pipe down to the lake. We thoroughly drained the pipes and the pump at the end of the summer. Perhaps the pipe-joint compound used by the installer dried up and let water into the pipe-to-pump threads, which caused the rust over the years. --Jon
I have seen similar failures due to conditions we can't easily test for. Your sink drain provides a good example, although I'd think the manufacturer--knowing the use conditions--would have tested drains under different water conditions. Maybe a cheap knock-off manufacturer went for low cost instead of quality. --Jon
Was the pipe carbon steel or stainless steel? I wouldn't expect a galvanic couple between carbon steel and cast iron, but depending on the type of stainless, there could be a significant galvanic couple between stainless and cast iron. A plastic or rubber isolator between the two could help prevent this.
Jon, I understand the difference between vibration, temperature, and corrosion tests, and know there are standards for each.
Applying the results of a vibration and temperature tests are MUCH easier to deciding the life of a component than it is to using the corrosion results.
The specifications for a component will say "up to 50g, 155deg F". It may even say something about the 20% salt bath immersion for 20 days.
I saw a new sink fixture component corrode away in 5 years on city water when I was a kid. I think it would be difficult to relate the corrosion test results to city water to come up with an expected lifetime.
People would run special corrosion tests, which many commercial test labs know how to perform. The "shake-and-bake" tests look for structural weaknesses at various frequencies and g levels, while the environmental temperature tests look for premature electrical and electronic failures as well as failures induced by the stresses and strains created by heating and cooling. --Jon Titus
On a related subject, the US National Institute of Science and Technology (NIST) recently published information about the failures of carbon nanotubes used as electrical conductors in microcircuits. Tests showed failures of the nanotubes after only 40 hours. Although many researchers have touted the capabilities of these carbon structures to carry high currents, they seem to have problems that deserve more research before companies use them in integrated circuits. You can read the complete article at: http://www.nist.gov/public_affairs/tech-beat/tb20110816.cfm#cnt. --Jon Titus
Those types of tests should be part of a comprehensive testing program, but many small companies lack a strong background in testing or they lack the time and money to have a contract company run them. Also, when a company custom builds mechatronic equipment, they might not think such tests deserve attention for one-off designs. Also, I doubt many colleges or universities teach engineers about real-world product or system tests. --Jon
Sorry to hear about your pump, Jon. Aren't the so-called "shake and bake" tests a standard best practice for mechanical parts and assemblies or is that just another example of a no-brainer routine falling through the cracks due to engineering short cuts?
In many engineering workplaces, there’s a generational conflict between recent engineering graduates and older, more experienced engineers. However, a recent study published in the psychology journal Cognition suggests that both may have something to learn from another group: 4 year olds.
Conventional wisdom holds that MIT, Cal Tech, and Stanford are three of the country’s best undergraduate engineering schools. Unfortunately, when conventional wisdom visits the topic of best engineering schools, it too often leaves out some of the most distinguished programs that don’t happen to offer PhD-level degrees.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.