That's an excellent point, Dave. Those who oppose RoHS on scientific grounds do indeed discuss its danger (or lack of) in the product's useful life and after disposal. You're correct about the "birth" part where there would be plenty of exposure.
I thought the whole point of RoHS was that it considers the product from cradle to grave. The fact that lead may not leach out of a soldered joint in a landfill doesn't mean that the use of leaded solders is environmentally benign. In this case, the risks are at the cradle, rather than the grave. The same goes for chromate conversion coatings. I don't think a chromated die casting presents much of a threat to the environment - but a a chromate line obviously does.
In my field (marine engines), we still use a lot of RoHS restricted substances, including cadmium, hexavalent chromium, etc. We are actively looking for good alternatives, and already have a few in place. The U.S. Department of Defense has actually a lot of helpful work in this regard.
There has been a lot of confusion in the U.S. about exactly what RoHS is, what it applies to, etc. I'm sure that these changes will only increase the confusion.
Good points, sensor pro. One of the reasons IPC fought so hard to make sure RoHS changes were based on proven science going forward is because many in the electronics industry criticized the banning of lead in solder, insisting that the EU didn't base the decision on proven science. Many materials experts insist the lead in solder won't leach out in a landfill and they have challenged the EU to prove otherwise, to no avail.
The fact that IPC won on this point during the RoHS Recast is significant.
This is the only positive news in this whole ROHS issue. We still produce for ourselves withoiut ROHS. I still see too mane peoduction issue which in my opinion dod not justify this ROHS mess. Just last week some connectors melted while in automatic assembly due to high temperature. They all were ROHS, however with a very borderline thermal chanracteristics. Now we need to look for an even more expensive part. We were producing this product to over 10 years without any problem. Now we have burnt connectors and overheated ICs. Also during rework, the ROHS solder smells terrible. I really fail to see any serious benefits. Am I the only one with negative views?
If your markets are only in the United States RoHS has no affect. There are medical equipment manufacturers and many defense manufacturers who are not affected by RoHS. Global manufacturers, however, have adopted the RoHS restrictions since they don't know which of the products might end up on the European market.
The biggest change in the RoHS Recast is that some portions of the electronics market are no longer exempt from RoHS restrictions. That includes medical electronics. So, if you're a medical electronics producer with a global market, the RoHS restrictions may be newly applicable.
So far, there is no credible movement in the United States to create a domestic RoHS.
Seems like we've been hearing a lot about new RoHS guidelines as of late--I believe Rob, you wrote something recently about new regulations in India. My question is what does all this mean for engineering and manufacturing groups in the States given that Europe is obviously a key market for them and will these new stronger rules finally pave the way for similar and subsequent regulations here?
What should be the perception of a product’s real-world performance with regard to the published spec sheet? While it is easy to assume that the product will operate according to spec, what variables should be considered, and is that a designer obligation or a customer responsibility? Or both?
Biomimicry has already found its way into the development of robots and new materials, with researchers studying animals and nature to come up with new innovations. Now thanks to researchers in Boston, biomimicry could even inform the future of electrical networks for next-generation displays.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.