Because of time difference ( India ) I was unable to participate immediately.
It was an excellennt presentation. I am a hardware engineer and may be I understand the logic behind the software. I cannot go into codes directly. I am looking for the design of Microcontroller for Motor Control applications in Automative applications. The temperature within the enclosure of this system to be planned is 180 deg Celcius. The competitors use ST Micrpcontroller L9805. The requirement is very precise control of the motor speed with position feedback, appropriate acceleration and deceleration. Uses CAN bus Communication from Engine Unit.
Mr Warren, I would appreciate if you can suggest a suitable microcontroller to work at high temperature, automative applications very reliably. Where can I get some reference designs.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.