I average 18mph (burst of up to 30mph) on a7 mile ride and I have never been unable to hear approaching cars from behind. Do I trust my ears alone? No. But I've never been surprised by Prius, Volt, Tesla Roadster, or any other hybrid or electric vehicles. In biking events or on bike paths I can even hear approaching bicycles from behind (bike chain, wind, and tire noise). So I'm surprised that wind noise overpowers car noises for you.
It's been interesting to see all the comments about this! Obviously it's struck a nerve...and danger aside, I'm happy to see a number of people less than thrilled about the idea of noisier hybrids and EVs. There has to be a better solution.
The 1865 act required all road locomotives, which included automobiles, to travel at a maximum of 4 mph (6 km/h) in the country and 2 mph (3 km/h) in towns and have a crew of three travel, one of whom should carry a red flag walking 60 yards (55 m) ahead of each vehicle.
Backup audible warning is already implemented on most trucks, commercial vehicles, municipal vehicles, etc. That is not a bad idea; the driver has limited view, and risk is higher. But that is totally different than always on noise generators.
The engineers and inventors of the post WWII period turned their attention to advancements in electronics, communication, and entertainment. Breakthrough inventions range from LEGOs and computer gaming to the integrated circuit and Ethernet -- a range of advancements that have little in common except they changed our lives.
The age of touch could soon come to an end. From smartphones and smartwatches, to home devices, to in-car infotainment systems, touch is no longer the primary user interface. Technology market leaders are driving a migration from touch to voice as a user interface.
Soft starter technology has become a way to mitigate startup stressors by moderating a motor’s voltage supply during the machine start-up phase, slowly ramping it up and effectively adjusting the machine’s load behavior to protect mechanical components.
A new report from the National Institute of Standards and Technology (NIST) makes a start on developing control schemes, process measurements, and modeling and simulation methods for powder bed fusion additive manufacturing.
If you’re developing a product with lots of sensors and no access to the power grid, then you’ll want to take note of a Design News Continuing Education Center class, “Designing Low Power Systems Using Battery and Energy Harvesting Energy Sources."
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.