GM's Robo-Glove incorporates four tiny servo motors, four gearheads, and four ball screws, along with a lithium-ion battery, in a package worn on the forearm. The motors apply force through synthetic tendons attached to the fingers. (Source: GM)
As Rob has indicated here, GM will likely commercialize this through licensing. Make no mistake, though, even though they are not planning to mass produce it themselves, they are very serious about commercialization. And they are open to ideas for innovative ways to use the technology.
Chuck, Very cool development. The packaging of the system (motors and ballscrews) must have been a significant challenge with this. Great to see the linkage to their work with NASA on the humanoid robot project.
Itis good to see GM put engineering labor and cost into something that helps their employees health and well being. If this technology is deployed in their factory and their repetetive motion injury rate goes down, the result to their bottom line will be substantial.
Beth, i had a similar conversation with Chuck about this the other day. Chuck, can you elaborate on whether GM has plans to mass produce this product, or will they use it internally? In any case, it will be interesting to see what type of companys will employ the Robo-Glove.
I've read about a couple of projects in this area lately, but this seems to go a step further with the intelligent sensors that make some sort of interpretation as to how the user wants to operate the hand. That seems pretty advanced in my book. Is this something GM is developing for use internally or would there be commercial applications/availability for it outside of automotive manufacturing? Seems odd that GM would spend time developing/commercializing something a competitor might use.
The engineers and inventors of the post WWII period turned their attention to advancements in electronics, communication, and entertainment. Breakthrough inventions range from LEGOs and computer gaming to the integrated circuit and Ethernet -- a range of advancements that have little in common except they changed our lives.
The age of touch could soon come to an end. From smartphones and smartwatches, to home devices, to in-car infotainment systems, touch is no longer the primary user interface. Technology market leaders are driving a migration from touch to voice as a user interface.
Soft starter technology has become a way to mitigate startup stressors by moderating a motor’s voltage supply during the machine start-up phase, slowly ramping it up and effectively adjusting the machine’s load behavior to protect mechanical components.
A new report from the National Institute of Standards and Technology (NIST) makes a start on developing control schemes, process measurements, and modeling and simulation methods for powder bed fusion additive manufacturing.
If you’re developing a product with lots of sensors and no access to the power grid, then you’ll want to take note of a Design News Continuing Education Center class, “Designing Low Power Systems Using Battery and Energy Harvesting Energy Sources."
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.