Rob, that's just what I have been saying! It is interesting that in Formula 1 racing the turbocharged engines are limited to 1.5L as oppossed to the naturally aspirated engines at 3.0L. Just an aside, these engines put out over 700HP. We can get the horsepower we need to drive our vehicles with less fuel, but it will take lots of engineering to make them as reliable as the current engines. This is just one good example of an engineering "detail" that is critical to success.
I agree Naperlou. With all of the attention on the innovation going into EVs and hybrids, I think some of the innovation on traditional gas engines is getting overlooked. In the long run, improved internal combustion engines may save more gas than electric vehicles.
Way back (late 1960's) when I worked summers as a part-time janitor for a school district, they had cleaning supplies deliverd in fibre drums (sweeping compound, etc). The lids on these drums were retained with exactly the same form device with the band in a U or V form to lock the lid to the top rim of the drum and with either a draw screw or over-center-snap link to draw thins tight.
OK this is a high temp alloy as needed by the application, but this is not new.
I believe you missed the point they are trying to make. I would blame the author for not showing an illustration of the thread form. It is not the V-Band Clamp that they are talking about as new. It is the thread form that they refer to as Spiralock. By the way, this thread form is not new either. Someone just seem to be promoting it for a new found application.
Spiralok has been around for a long time, but engineering folks need to be reminded or newly presented with this product's capability, every so often. I still have a Spirolok demonstration assembly on my desk. It reminds me of this potential solution, every time I glance at it. Many coworkers have picked it up and examined it, over the years.
The part in the photo looked very familiar. I went to my "secondary" desk behind me and picked up the part. The photo looks identical except mine has a hole for safety wire. The inner part is made up of two 180 degree parts, each with a "thread" cut on the inside and the clamp holds both parts together. It is used on a Gulfstream G1 turboprop 40kw auxillary power unit. The plane itself was built in 1958! This mechanism was designed so one mechanic could hold the heavy generator in place while another attached the "nut" to remove the loading. The strap holds it all in place and is safety wired to prevent it from coming apart unexpectedly in the air, always bad juju! It was no doubt an expensive part. It appears that auto manufacturers have found a cheaper was to fabricate them, but it is most certainly not new.
What makes this movie stand out from the typical high school sports story is that the teenagers are undocumented immigrants, and the big game is a NASA-sponsored marine robotics competition. Like many other Hollywood movies, however, Spare Parts only tells part of the story. What the film shows -- and doesn’t show -- raises important issues affecting STEM education in the US.
Instead of sifting through huge amounts of technical data looking for answers to assembly problems, engineers can now benefit from 3M's new initiative -- 3M Assembly Solutions. The company has organized its wealth of adhesive and tape solutions into six typical application areas, making it easier to find the best products to solve their real-world assembly and bonding problems.
Load dump occurs when a discharged battery is disconnected while the alternator is generating current and other loads remain on the alternator circuit. If left alone, the electrical spikes and transients will be transmitted along the power line, leading to malfunctions in individual electronics/sensors or permanent damage to the vehicle’s electronic system. Bottom line: An uncontrolled load dump threatens the overall safety and reliability of the vehicle.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.