Another story came out yesterday, saying that Boeing intends to provide more space between cells. It's worth mentioning, however, that Boeing's spokespeople are not commenting, so we don't know for sure.
I saw a graphic that Boeing was going to stick a vented containment around the existing battery box. I doubt that will satisfy the FAA and NTSB. Aside of the whole qualification time lag, why wouldn't they swap the Lion battery units with NiMH-based assemblies? Since they seem to have the space to put a box around the existing box, they could definitely go to a lower energy density battery technology.
this link shows some of the aviation incidents involving smoke, fire, extreme heat or explosion - and we continue to fly. 787 battery issue is a marketing issue, I hope the Dreamliner wil not change the name to Incubusliner.
@g_ost: It's hard to tell whether Airbus's decision to switch to NiCd for the A350 is more about public relations or safety. They've been flying A350s with lithium-ion batteries successfully so far. But being able to say that they don't have the "bad" battery chemistry that Boeing has may give Airbus an advantage with customers and regulators.
Due to 787 battery problems Airbus dispensed for A350 to the installation of lithium batteries. The first aircraft will be delivered with cadmium batteries, not lithium batteries. But the first test flights will attend Airbus with lithium batteries.
For large capacity multi cell series/parallel batteries each series stack typically will have its own controller. If thermal runaway begins in one cell, the consensus seems to be removing the charging current will NOT stop the runaway. See the nfpa link:
Other links regarding marine applications of lithium-ion batteries indicate that monitoring the individual cells (series stacks) is absolutely critical to prevent runaway. If this degree of protection is reasonable for a boat, I can't imagine it isn't practiced on an aircraft.
Yes, isolating each cell physically and electrically is doable, at a cost - but, if due to manufacturing defect or degradation over time, a cell develops an internal short, is it sufficient to just stop the charging current? Or will the stored energy through the short circuit lead to thermal runaway anyway? Does anybody here know?
The engineers and inventors of the post WWII period turned their attention to advancements in electronics, communication, and entertainment. Breakthrough inventions range from LEGOs and computer gaming to the integrated circuit and Ethernet -- a range of advancements that have little in common except they changed our lives.
The age of touch could soon come to an end. From smartphones and smartwatches, to home devices, to in-car infotainment systems, touch is no longer the primary user interface. Technology market leaders are driving a migration from touch to voice as a user interface.
Soft starter technology has become a way to mitigate startup stressors by moderating a motor’s voltage supply during the machine start-up phase, slowly ramping it up and effectively adjusting the machine’s load behavior to protect mechanical components.
A new report from the National Institute of Standards and Technology (NIST) makes a start on developing control schemes, process measurements, and modeling and simulation methods for powder bed fusion additive manufacturing.
If you’re developing a product with lots of sensors and no access to the power grid, then you’ll want to take note of a Design News Continuing Education Center class, “Designing Low Power Systems Using Battery and Energy Harvesting Energy Sources."
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.