Siemens Adds Ethernet to Sinamics Drives to Enable Single-Plant Network
Siemens has added support for industrial Ethernet to its Sinamics S120 drive system, providing flexibility for the manufacturer that wants to deploy a single network across its facilities. (Source: Siemens)
This is a good thing especially for large manufacturing operations, EtherNet/IP and Profinet running on a single controller. I would think it would be especially useful when it comes to communications between machine cells and different OEM machines.
It's VERY surprising to see Siemens put Ethernet/IP into these drives, but very smart. It means they can be integrated tightly into a Rockwell Automation PLC. It's a great way to get their foot in the door of Rockwell's dominance in US industrial automation.
Interesting the support for EtherNet/IP in the new Sinamics drives. I'm sure this will be a good development especially for some machinery OEMs and plants that have standardized on that protocol. Increases flexibility. Could be a trend to support competing protocols, and I expect we'll continue to see more of this kind of development from other automation control suppliers as well.
The engineers and inventors of the post WWII period turned their attention to advancements in electronics, communication, and entertainment. Breakthrough inventions range from LEGOs and computer gaming to the integrated circuit and Ethernet -- a range of advancements that have little in common except they changed our lives.
The age of touch could soon come to an end. From smartphones and smartwatches, to home devices, to in-car infotainment systems, touch is no longer the primary user interface. Technology market leaders are driving a migration from touch to voice as a user interface.
Soft starter technology has become a way to mitigate startup stressors by moderating a motor’s voltage supply during the machine start-up phase, slowly ramping it up and effectively adjusting the machine’s load behavior to protect mechanical components.
A new report from the National Institute of Standards and Technology (NIST) makes a start on developing control schemes, process measurements, and modeling and simulation methods for powder bed fusion additive manufacturing.
If you’re developing a product with lots of sensors and no access to the power grid, then you’ll want to take note of a Design News Continuing Education Center class, “Designing Low Power Systems Using Battery and Energy Harvesting Energy Sources."
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.