When they say they are trying to make the wires and cables, are they inferring the use of a combination of plastics and sintering printing? That would be incredible to mix the two technologies, then you could truly create some awsome things.
Thanks, everyone--isn't this fun? I think it was only a matter of time once the industry achieved the ability to "print" flexible electronics via lithography, as DN has covered in the past: http://www.designnews.com/author.asp?section_id=1392&doc_id=249722
Wow, what will be available for 3D printing next--a human being?? :) I'm just kidding, of course, but this story is impressive! Printing sure has come a long way from dot-matrix, hasn't it? Look forward to more developments in this area and the potential for doing this commercially someday. If it progresses I forsee a whole new era of at-home inventions and armchair mad professors being inspired!
Because of the increasing ubiquity of wearable technology, it would be easy to think that design of wearable devices is routine and involves common design and engineering knowledge. Missed efforts in development will be remembered once the devices are used in the field
This grab-bag of new fasteners and adhesives work with a range of materials they can attach to, as well as a wide variety of applications. Several are for use in consumer applications, such as wearables or other compact electronic assemblies, and some of the adhesives have extended service temperature ranges and cure at room temperature.
As governments, associations, and NGOs around the world seek to protect consumers, national and regional standards are becoming mandatory, challenging manufacturers and making testing and certification necessary for any product developed and brought to market.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.