Research from the European Space Agency has helped to develop an aircraft-grade titanium-aluminum alloy that's half the weight of conventional nickel superalloys but has similar properties. This alloy could make jet turbine blades (such as this one shown in flight) 45 percent lighter. (Source: Creative Commons–A. Rueda)
The cost of titanium isn't as astronomical as it used to be, based on information I've heard from several manufacturers that make fasteners, engine parts, and other components for the aerospace industry. Prices have been declining for a decade or so, as new sources have become available. Combining it with aluminum, as in this alloy, has helped to bring that cost down even more.
@Ann: Thanks for posting this. Metals and metalcasting are two of my favorite topics.
Nickel aluminide has been around for decades, but it is difficult to cast, so it is only in the past few years that it has started to be taken seriously as an alternative to superalloys in turbine applications. General Electric uses investment-cast nickel aluminide for the low-pressure turbine blades in its GEnx engines, and also uses a nickel-aluminide coating on the high-pressure turbine blades. NASA did a lot of work to support this.
It will be interesting to see whether casting in this type of centrifuge is a practical manufacturing method.
Interesting article but there are some practical realities to overcome.
There are three types of blades in a modern gas turbine engine--fan, compressor, and turbine. The fan blades form the large fan at the front of the engine that essentially acts like a propeller (or bird shredder) and operates at low temperatures. FAA engine certification rules designate the fan blade a critical part as failure can result in conditions hazardous to continued flight.
Compressor and turbine blades are not considered critical in this respect as the thinking is even if a failure occurs and the engine is shut down as a result, the fragments exit the tailpipe with no hazard to continued safe flight of the aircraft. One may argue that an engine shutdown is unsafe although the aircraft is certified to fly on one engine. Blades are extremely high integrity parts.
Maybe this is a leap in metallurgical technology however we are a long way from replacing reliable and durable single crystal nickel superalloys with any titanium alloy in the hot section of gas turbine engines. Current designs are running turbine inlet gas temperatures above the melting point of the nickel blade and vane materials--cooling is key here and this design requirement demands internally cooled blade and vane castings that are difficult to produce.
The cold (compressor) section may be more suitable for the material although again current designs are pushing temperatures at the compressor exit above 1200F. For fan blades applications, integrity will have to be demonstrated rigorously. Composites are currently used in this application with great success to reduce weight.
Also any practical use must consider the fabrication cost of the material which appears astronomical.
More often than not, with the purchase of a sports car comes the sacrifice of any sort of utility. In other words, you can forget about a large trunk, extra seats for the kids, and more importantly driving in snowy (or inclement) weather. But what if there was a vehicle that offered the best of both worlds; great handling and practicality?
Science fiction author Isaac Asimov may have the best rules for effective brainstorming and creativity. His never-before-published essay, "On Creativity," recently made it to the Web pages of MIT Technology Review.
Much has been made over the potentially dangerous flammability of lithium-ion batteries after major companies like Boeing, Sony, and Tesla have grappled with well-publicized battery fires. Researchers at Stanford University may have come up with a solution to this problem with a smart sensor for lithium-ion batteries that provides a warning if the battery is about to overheat or catch fire.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.