It's still painful to set up wireless networks at home sometimes when you buy a router. I can't imagine having to set up a whole device-to-device and machine-to-machine network on the factory floor and beyond, even if you have the know-how. I think NFC can definitely ease that pain a bit.
Your observation is absolutely right. Even for the tech savvy , setting up the connectivity may be tough. TI has understood the pain point and came up with a solution that will enahnce the workflow by improving the userfriendliness.
TI is making an interesting choice here in choosing NFC for its connectivity but I think it makes good sense. As the TI's Pradhan points out, it should make getting all these things linked up a bit easier. I think the idea of connectivity is daunting for alot of device users/makers, and simplifying it will make the IoT become less an idea and more of a reality that much quicker.
Great post Charles. The most encouraging statement was as follows: "Setting up those connected systems to the everyday things in our lives can be tedious," Pradhan told us. "There's always a load of instructions that need to go back and forth between the router and the device. NFC, at a very fundamental level, makes it all easier." The word easier is most appealing. I'm one of those guys who enjoys the outcome of the "new hardware" and not the labor going into setting up the device or devices. Welcome advance in technology.
Did I read the same article? I oonly saw printers mentioned once. I think printers are still used quite often. If not then the stores like Best Buy would not sell them. Last time I was in there, they had a good selection to choose from. I guess they are in there for decorations.
Most cyber attacks could be avoided by adopting a list of Critical Security Controls that were created by the Center for Internet Security. That’s the message from Steve Mustard of the Automation Federation.
How 3D printing fits into the digital thread, and the relationship between its uses for prototyping and for manufacturing, was the subject of a talk by Proto Labs' Rich Baker at last week's Design & Manufacturing Minneapolis.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies.
You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived.
So if you can't attend live, attend at your convenience.