A knit line is any line, visible or not, where two resin flows meet. Depending on the design of the mold and the material being injected, a knit line may present no problem at all, may be a cosmetic issue, or may cause a serious structural problem.
Good article. In many electromechanical assemblies, Agency requirements can matter also. A polymer may be the perfect match for the strength, finish, etc. needed for the product. However, that particular grade of polymer may not have the flame retardant properties needed to pass 94V-0 at the specified thickness in order to achieve agency certification for the entire product. It is important to also consider agency requirements up front during product development to make sure the entire product can be certified.
Two new technologies from Stratasys, created in partnership with Boeing, Ford, and Siemens, will bring accurate, repeatable manufacturing of very large thermoplastic end products, and much bigger composite parts, onto the factory floor for industries including automotive and aerospace.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies.
You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived.
So if you can't attend live, attend at your convenience.