These all should be the standard set of design requirements in any project. When this the basics start getting overlooked?
The problem with standardizing the power connection is not about the charging, but its use as a communication port as well. As data demands start surpassing the port's bandwidth, the connector has to change. USB 3.0 has the potential to be the next universal plug, but that may get outstripped as HD content demands increase.
So, don't expect a universal standard any time soon.
I agree, Greg. It's great to read an article about cooperation with something that seems so obvious yet has not been implemented in the past, I am guessing because companies wanted to maintain control and therefore the profit of their own chargers. Over voltage protection is a common engineering practice for a well-designed circuit and universal chargers just make so much more sense!
There was movement in the past to require by law that all chargers had the same power connector. Several years later, they are not. But many companies as joined together to standardize the port. Like all standardizations, have common ground will help a lot of companies make new products. Especially when that standard is free to use. Open that up, and everyone will hop on board. But like Moore's law demands doubling of processing power, so follows the communication ports.
I think the best way to go on this subject is wireless charging and data communication. Look at the company Witricity, they are trying to push a magnetic resonance charging system that has little loss over sizable distances. It looks very promising, and shows the what is next.
No kidding, since nearly every phone has some sit of USB connector, why can,t that serve as the charger port? Yes, this means some sort of charge in the phone, but it could be a featureless charge that just got a few electrons into the battery.
Great idea to commonize chargers and require manufacturers to meet more universal standards. Hopefully, this will not only result in less landfill waste, but also increased safety across the entire product spectrum.
Major changes are happening in the world of 3D printing and additive manufacturing materials, machines, and software. If the industry -- and the design engineers and OEMs it serves -- are to grow, all three areas must become much more tightly integrated.
Americans spent more than $60B on their pets in 2015. Folks are definitely spending their money on more than dog food. We’re spending on things like dog spas and fancy toys, and as you can imagine, the wearables market is becoming well represented here.
Time was when sports equipment was made only from common, everyday, low-tech materials. But now sports equipment has a new, high-tech ingredient that is helping players take their game to the next level.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.