When they say they are trying to make the wires and cables, are they inferring the use of a combination of plastics and sintering printing? That would be incredible to mix the two technologies, then you could truly create some awsome things.
Thanks, everyone--isn't this fun? I think it was only a matter of time once the industry achieved the ability to "print" flexible electronics via lithography, as DN has covered in the past: http://www.designnews.com/author.asp?section_id=1392&doc_id=249722
Wow, what will be available for 3D printing next--a human being?? :) I'm just kidding, of course, but this story is impressive! Printing sure has come a long way from dot-matrix, hasn't it? Look forward to more developments in this area and the potential for doing this commercially someday. If it progresses I forsee a whole new era of at-home inventions and armchair mad professors being inspired!
This year, Design News is getting a head start on the Fourth of July celebration. In honor of our country and its legacy of engineering innovation -- in all of its forms -- we are taking you on an alphabetical tour through all 50 states to showcase interesting engineering breakthroughs and historically significant events.
Earlier this year paralyzed IndyCar drive Sam Schmidt did the seemingly impossible -- opening the qualifying rounds at Indy by driving a modified Corvette C7 Stingray around the Indianapolis Motor Speedway.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.