Another place these plastic bearings are being used is in a concept car, the Personal Transport Vehicle by Redbud Technology http://www.redbudtechnologyllc.com/3.html according to an igus press release I just saw here http://igus.com/Corporate/Press/5536/student-built-personal-transport-vehicle-uses-plastic-bearings
Cost effective, robust and easy to manufacture? What's not to like but like, however I agree with William in that it depends on the application as well as the environment on which type of bearing works best.
Plastic bearings do offer very real advantages in some applications, but it is absolutely vital to assure that the bearing selected is adequate for the application. Of course, that is true with all bearing types, but sometimes the failure of an incorrectly applied plastic bearing can be quite impressive, even spectacular. So just as with other types of bearings, the application is not a trivial matter. The correct selection will assure satisfactory performance.
The resistance to water and other liquids that are quite hard on regular bearings can be a very big benefit.
Very informative post Michael. One of the most difficult consulting jobs I have ever had was specifying bearings for conveyors used in a chain of bakeries. The issue was sugar granules getting into the bearing components and creating a remarkably short bearing life. Sealed bearings did not seem to do the job adequately. For this one department, I did specify a polymer. That saved the day. Again, very good post. Good information.
This is a very interesting article on plastic ball bearings...from what I understand they are also lighter and quieter than other types. I wonder what the cost comparison is regarding steel or ceramic ball bearings but you would also have to factor in the plastic bearings comparitively lower maintenance and longer expected cycles into the equation...
No lubrication needed with these types of bearings is a key feature. Dust and contaminates will eventually settle on the operating surfaces and cause performance degradation. This feature (along with preventing food contamination) is an important advantage with this product over lubricated bearings.
The engineers and inventors of the post WWII period turned their attention to advancements in electronics, communication, and entertainment. Breakthrough inventions range from LEGOs and computer gaming to the integrated circuit and Ethernet -- a range of advancements that have little in common except they changed our lives.
The age of touch could soon come to an end. From smartphones and smartwatches, to home devices, to in-car infotainment systems, touch is no longer the primary user interface. Technology market leaders are driving a migration from touch to voice as a user interface.
Soft starter technology has become a way to mitigate startup stressors by moderating a motor’s voltage supply during the machine start-up phase, slowly ramping it up and effectively adjusting the machine’s load behavior to protect mechanical components.
A new report from the National Institute of Standards and Technology (NIST) makes a start on developing control schemes, process measurements, and modeling and simulation methods for powder bed fusion additive manufacturing.
If you’re developing a product with lots of sensors and no access to the power grid, then you’ll want to take note of a Design News Continuing Education Center class, “Designing Low Power Systems Using Battery and Energy Harvesting Energy Sources."
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.