mcj804: The engine puts out 9.5 bhp, not 13. The 13 lbs cited in the story is the amount of boost from the supercharger. The article doesn't give the weight of the engine, so we can't compute the engine's power to weight ratio. The correct way to evaluate the power output is to say that its specific output is 1.56 bhp/cu.in. This is pretty good. Two of the highest output American V8 engines are those in the 2013 Ford Shelby GT500 (1.86 bhp/cu.in.) and the 2013 Corvetter ZR1 (1.69 bhp/cu.in.). The V6 in the 2012 Honda Accord EX-L is rated at 1.28 bhp/cu.in.
I, too, am impressed. The challenges must have been incredible! It goes to show that things aren't always to simple as they might first appear. Just like when they were scaling down IC manufacturing, the smaller lines created all sorts of optical and delivery problems.
Too bad I didn't get to see it. I am always impressed by someone who does a really good job! Kudos to you and your team!
It is quite an accomplishment and praiseworthy indeed. However, developing 13hp is a far cry more down-sized than the 1/4 size scale of the engine. One would expect a great deal more than 130hp from a full-sized super-charged V8. It appears that the power-to weight ratio doesn't scale very well.
Kudos for overcoming the difficulties and achieving this amazing engine.
I have to agree with the general tone of most responses that this is an amazing engineering achievement. A supercharged V-8 is already loaded with engineering innovation. To shrink that down to 1/4 size, I'm sure Mr. Conley had to solve more problems than just this oil retention issue. With national mandates to improve passenger car mpg, this development may not seem quite so out of the mainstream a few years from now.
The engineers and inventors of the post WWII period turned their attention to advancements in electronics, communication, and entertainment. Breakthrough inventions range from LEGOs and computer gaming to the integrated circuit and Ethernet -- a range of advancements that have little in common except they changed our lives.
The age of touch could soon come to an end. From smartphones and smartwatches, to home devices, to in-car infotainment systems, touch is no longer the primary user interface. Technology market leaders are driving a migration from touch to voice as a user interface.
Soft starter technology has become a way to mitigate startup stressors by moderating a motor’s voltage supply during the machine start-up phase, slowly ramping it up and effectively adjusting the machine’s load behavior to protect mechanical components.
A new report from the National Institute of Standards and Technology (NIST) makes a start on developing control schemes, process measurements, and modeling and simulation methods for powder bed fusion additive manufacturing.
If you’re developing a product with lots of sensors and no access to the power grid, then you’ll want to take note of a Design News Continuing Education Center class, “Designing Low Power Systems Using Battery and Energy Harvesting Energy Sources."
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.